Galileo TCP/IP Print Server manual Changing TCP/IP Network Information

Page 6

Changing TCP/IP Network Information

From the TCP/IP Print Server Configuration Utility, arrow left to the CONFIGURE drop down menu.

File Configure Help

IP Stack

Network Parameters

Printer Ports

Manual Override

Arrow to select “IP STACK” or press “I”.

This Machine’s Address:

__0. __0. __0. __0

Subnet Mask:

__0. __0. __0. __0

Default Gateway Address:

__0. __0. __0. __0

ESC to Cancel, CTRL + ENTER to Store

The IP addresses and Subnet Mask should be pre-filled with the machine’s previous configuration (initial configuration will show all zeros as indicated above). Over type the old configuration data with the new. If an IP address has an octet less then three characters in length, DO NOT ENTER A LEADING ZERO (example: enter “15” not “015”).

When finished, press CTRL+ENTER to store.

IF CONFIGURATION IS COMPLETE, REMEMBER TO SAVE AND BACKUP THE CONFIGURATION!

TCP/IP Print Server – Changing TCP/IP or Host Access Configuration (10/29/01 mlr)

6

Image 6
Contents Galileo International Copyright Before you begin Config Server Address ... PrimaryIntroduction SecondaryAccessing the TCP/IP Print Server Configuration Utility TCP/IP Print Server Configuration UtilitySave and Back-up Print Server Configuration Changing TCP/IP Network Information Arrow to select IP Stack or pressArrow to select Network Parameters or press N Assigning GTIDs to the correct Artic Card Port Arrow to select Printer Ports or press P