Wine Storage | 63 |
Model
DUAL FLUSH INSET INSTALLATIONS
Installing two models
Dual installations without a filler strip can only be accom- plished using two units with opposite hinges as shown in illustration A below. The dual installations shown in illus- trations B and C require a filler strip. Illustration A is the only application that will accommodate the dual wide grille.
IMPORTANT NOTE: The application shown in illustration A can only be achieved by installing dual flush inset panels. Failure to install dual flush inset panels will cause the handle side of the panels to collide when closing. In this application a dual installation accessory kit is also required.
Dual flush inset panels and dual installation kits are avail- able through your
subzero.com/specs
DUAL FLUSH INSET PANEL SPECIFICATIONS
| H |
| A |
A | A |
| H |
| A |
| W |
ICBWS-30 Dual Flush Inset
DOOR | W | H |
Flush Inset Panel | 775 mm | 1772 mm |
Spacer Panel | 740 mm | 1751 mm |
Backer Panel | 756 mm | 1767 mm |
GRILLE | W | H |
Flush Inset Panel | 775 mm | 235 mm |
Spacer Panel | 740 mm | 211 mm |
Backer Panel | 756 mm | 227 mm |
WINDOW | W | H |
584 mm | 1581 mm | |
|
| A |
Location |
| 95 mm |
WITHOUT FILLER STRIP |
FILLER STRIP REQUIRED |
FILLER STRIP REQUIRED |
Grille panel dimensions listed are for a standard 2134 mm overall height of the unit. For a 2108 mm overall height, subtract 25 mm from grille panel height dimensions. For a 2235 mm overall height, add 102 mm to height dimensions. Width dimensions do not vary.
Illus. A | Illus. B | Illus. C |