Problems & Solutions
Problem | Solution |
Transmitter range indicator green light flashes | Receiver is out of range of transmitter. Move receiver |
| closer to transmitter. |
| Note: Range varies depending on surrounding |
| conditions such as noise levels, physical obstructions |
| and signal interference. |
| Transmitter power is off. Turn transmitter power on. |
| Channel switches are on different channels. Make sure |
| channel switches on both transmitter and receiver are |
| set to same channel. |
| Loose power cord connection and transmitter power is off. |
| Check transmitter power cord |
| No power to wall outlet and transmitter power is off. |
| Make sure light switch that controls power flow to wall |
| outlet is on. |
| Power is off because circuit breaker for room is off. |
| Make sure house fuses and circuit breakers are on. |
Receiver power indicator does not light | Receiver power is off. Turn receiver power on. |
| Batteries in receiver are weak or dead. Replace all |
| batteries with three, alkaline “AAA” (LR03) batteries |
| or use AC adaptor as power source. |
| Power is off because circuit breaker for room is off. |
| Make sure house fuses and circuit breakers are on. |
| No power to wall outlet and power is off. Make sure light |
| switch that controls power flow to wall outlet is on. |
Receiver low battery indicator red light flashes | Batteries in receiver are weak or dead. Replace all |
| batteries with three, alkaline “AAA” (LR03) batteries |
| or use AC adaptor as power source. |
Transmitter range indicator does not light at all | Transmitter power is off. Turn transmitter power on. |
| Loose power cord connection and transmitter power is off. |
| Check transmitter power cord |
| No power to wall outlet and transmitter power is off. |
| Make sure light switch that controls power flow to wall |
| outlet is on. |
| Power is off because circuit breaker for baby’s room is off. |
| Make sure house fuses and circuit breakers are on. |
You can hear conversations or sounds | There is signal interference due to other nursery monitors |
from other homes | on same channel or cordless telephone use. Change |
| channel switches on both transmitter and receiver to |
| eliminate source of interference. |
Hint: If, after checking all of these solutions, you believe that your transmitter power cord or AC adaptor are damaged, please contact
13