Digital Networks North America DNswitch 800 manual Spanning Tree Information

Page 31

Spanning Tree Information

The Spanning Tree Information screen displays a summary of the STA information for the overall bridge or for a specific port. To make any changes to the parameters for the Spanning Tree, use the STA Configuration and STA Port Configuration screens.

Spanning Tree

The parameters shown in the following figure and table describe the current bridge STA Information.

Figure 3-13. STA Information - Spanning Tree

 

 

Parameter

Description

Spanning Tree

Shows if the switch is enabled to participate in an STA-

State

compliant network.

Bridge ID

A unique identifier for this bridge, consisting of bridge priority

 

plus MAC address (where the address is normally taken from

 

Port 1).

Max Age

The maximum time (in seconds) a device can wait without

 

receiving a configuration message before attempting to

 

reconfigure.

Hello Time

The time interval (in seconds) at which the root device transmits

 

a configuration message.

Forward Delay

The maximum time (in seconds) the root device will wait before

 

changing states (i.e., listening to learning to forwarding).

Root Port

The number of the port on this switch that is closest to the root.

 

This switch communicates with the root device through this

 

port. If there is no root port, then this switch has been accepted

 

as the root device of the spanning tree network.

Designated Root

The priority and MAC address of the device in the spanning tree

 

that this switch has accepted as the root device.

Root Path Cost

The path cost from the root port on this switch to the root device.

Configuration

The number of times the spanning tree has been reconfigured.

Changes

 

Last Topology

The time since the spanning tree was last reconfigured.

Change

 

DNswitch 800

Configuring and Monitoring the Switch 21

Image 31
Contents Digital Networks Page Revision/Update Information DNswitch Web Management GuidePage FCC Class B Certification USA Safety Compliance Underwriters Laboratories Compliance Statement Page Table of Contents Index Digital Networks WebView Description FeaturesSystem Requirements This guide uses the following user input conventions ConventionsSetting an IP Address Setting Up Web ManagementSetting the Administrator Password Setting a Default GatewaySetting Trap Destinations Enabling Web Management Starting and Stopping Digital Networks WebViewAreas of the User Interface Digital Networks WebView User InterfaceAreas of the User Interface Configuration Options Using HelpScreen Hierarchy Configuring and Monitoring the SwitchParameter Description System InformationMain Board Switch InformationParameter Default Description IP ConfigurationSnmp Community Snmp ConfigurationTrap Managers Trap ManagersChange Password Security ConfigurationWeb Upload Management Firmware Upgrade OptionsTftp Download Management Tftp Download ManagementConfiguration Upload Management Configuration Save and RestoreConfiguration Download Management 12. Address Table Address Table ConfigurationSTA Spanning Tree Algorithm Spanning Tree Spanning Tree Information14. STA Information Ports Switch Spanning Tree Configuration16. STA Configuration When the Switch Becomes Root Enabled STA Port ConfigurationBridge Capability Configuring Bridge MIB ExtensionsGmrp Bridge SettingsPriority Port Priority Configuration21. Port Traffic Class Information Port Traffic Class InformationVlan ID Vlan ManagementVlan Basic Information Configuring Virtual LANs24. Vlan Current Table Vlan Current TableVlan Static Table Vlan Static List27. Vlan Static Table Port Assignment 28. Vlan Static Membership by Port Vlan Static Membership by PortPvid Vlan Port ConfigurationIgmp Multicast Filtering Configuring Igmp31. Multicast Router Port Information Multicast Router Port Information32. Static Multicast Router Port Configuration Static Multicast Router Port Configuration33. Igmp Member Port Table Igmp Member Port Table34. IP Multicast Registration Table IP Multicast Registration TablePort Information Port MenusDirectly to the switch when its buffers fill. Back Port Configuration37. Port Broadcast Storm Protect Configuration Port Broadcast Storm Protect Configuration38. Port Security Configuration Port Security Configuration39. Mirror Port Configuration Using a Port Mirror for AnalysisPort Trunk Configuration 40. Port Trunk Configuration Etherlike Statistics Port Statistics42. Rmon Statistics Rmon StatisticsBits but including FCS octets Configuring and Monitoring the Switch DNswitch Cannot Connect to the Switch TroubleshootingSystem is Disconnected from the Switch Can I Open More Than One Window for Same Switch? Frequently Asked QuestionsHow Do I Confirm a Successful Software Download? Index Vlan Page WM-DSA8G-00