Dell 2650 manual Recommended Tools, System Orientation

Back to Contents Page

Removing and Replacing Parts

Dell™ PowerEdge™ 2650 Systems Service Manual

Recommended Tools	Memory Modules
System Orientation	CD and Diskettes Drives
Bezel	SCSI Configuration Information
System Cover	External SCSI Tape Drive
Inside the System	Hard Drives
Control-Panel Cable Cover	Integrated RAID Controller
Front-Panel I/O Board	RAID Controller Card
Control Panel	SCSI Backplane Daughter Card
System Fans	SCSI Backplane Board
System-Fan Bracket	System Board Tray
Power Supplies	System Board Tray Levers
Expansion-Card Cage	Microprocessors
Expansion Cards	System Battery
Expansion-Card Riser Board	System Board

The procedures in this guide require that you remove the cover and work inside the system. While working inside the system, do not attempt to service the system except as explained in this manual and elsewhere in your system documentation. Always follow the instructions closely. Review all of the procedures in your System Information document.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your System Information document for complete safety information.

This section provides servicing procedures for components inside the system. Before you start any of the procedures in this section, perform the following tasks:

Read the safety information in the System Information document.

•Perform the procedures described in "External Visual Inspection."

When there is no replacement procedure provided, use the removal procedure in reverse order to install the replacement part.

Recommended Tools

You need the following items to perform the procedures in this section:

•Key to the system keylock

•#2 Phillips screwdriver

•Wrist grounding strap

System Orientation

The illustrations in this document are based on the positioning of the system as shown in Figure 4-1.

Figure 4-1. System Orientation