Dell 518 manual Replacing the System Board

Page 27

Back to Contents Page

Replacing the System Board

Dell™ Inspiron™ 518/519 Service Manual

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTICE: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could damage your system board. For technical service, see the Quick Reference Guide.

1.Follow the procedures in Before You Begin.

2.Remove the computer cover (see Removing the Computer Cover).

3.Remove any add-in cards on the system board (see Replacing a PCI/PCI Express Card).

CAUTION: The processor heat sink can get very hot during normal operation. Be sure that the heat sink has had sufficient time to cool before you touch it.

4.Remove the processor and heat sink assembly (see Removing the Processor).

5.Remove the memory modules (see Replacing Memory Module(s)) and document which memory module is removed from each memory socket so that the memory modules can be installed in the same location after the board is replaced.

NOTICE: Carefully note the routing and location of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly routed or a disconnected cable could lead to computer problems.

6.Disconnect all cables from the system board.

7.Remove the eight screws from the system board.

1 screws (8) 2 system board

8. Lift the system board up and out.

NOTICE: If you are replacing the system board, visually compare the replacement system board to the existing system board to make sure that you have the correct part.

NOTE: Some components and connectors on replacement system boards may be in different locations than corresponding connectors on the existing system board.

NOTE: Jumper settings on replacement system boards are preset at the factory.

9.Orient the system board by aligning the screw holes on the system board with the screw holes on the chassis.

10.Replace the eight screws to secure the system board to the chassis.

11.Replace the cables that you removed from the system board.

12.Replace the processor and the heat sink assembly (see Installing the Processor).

NOTICE: Ensure that the heat sink assembly is correctly seated and secure.

Image 27
Contents Page Recommended Tools Technical SpecificationsSafety Instructions Before You BeginBack to Contents Installing a PCI/PCI Express Card Replacing a PCI/PCI Express CardRemoving a PCI/PCI Express Card Replacing the Card Retention Bracket Installed Removed Sound Replacing the Battery Replacing the Computer Cover Removing the Computer Cover Removing the Processor Replacing the ProcessorInstalling the Processor Dell Inspiron Replacing a Hard Drive Replacing DrivesSATA0 SATA3 Replacing a CD/DVD DriveSATA3 Replacing a Media Card ReaderRemoving the FlexBay Break-Away Metal Plate Replacing the Drive Panel Insert Replacing the Processor Fan and Heat Sink Assembly Replacing FansReplacing the Chassis Fan Inspiron Back to Contents Replacing the Front Panel Replacing the Front I/O Panel Replacing Memory Modules Back to Contents Replacing the Power Supply Back to Contents Replacing the System Board Back to Contents Overview System SetupAdvanced Bios Features Boot Sequence Changing Boot Sequence for Future Boots Clearing Forgotten PasswordsFlashing the Bios Clearing Cmos SettingsBack to Contents Technical Overview Inside View of Your ComputerSystem Board Components Cpufan SATA2
Related manuals
Manual 64 pages 1.57 Kb