Dell 4x00, 6x00 manual LJXUH,QVWDOOLQJWKH5DFN$GDSWHUVDQG5DLOV

1.Remove the feet from the computer:

a.Lay the computer on its left side on a piece of foam or cardboard (to prevent damage to the computer).

b.Using a small flat-blade screwdriver, unscrew the screw securing each foot.

c.From outside of the computer chassis, pull each foot from the chassis.

2.Remove the rubber plugs from the screw holes on the computer’s side panel.

3.Install three rails on one side of the computer (see Figure 9).

Orient each rail so that the three holes on the end of the rail are near the back of the computer. Attach each rail with four 10-32 x 0.25-inch Phillips-head screws.

4.Tighten the 10-32 X 0.25-inch screw finger tight so that each of the rails are able to move up and down slightly.

10-32 x 025.-inch screws (4) securing each rail

UDLOV￿￿￿￿

UDFN￿DGDSWHUV￿￿￿￿

￿￿￿￿￿￿[￿￿￿￿￿￿LQFK￿VFUHZV￿￿￿￿￿

VHFXULQJ￿HDFK￿UDFN￿DGDSWHU

)LJXUH￿￿￿￿￿,QVWDOOLQJ￿WKH￿5DFN￿$GDSWHUV￿DQG￿5DLOV

5.Install the rack adapter on the computer (see Figure 9).

Secure the adapter to the computer with three 10-32 x 0.25-inch Phillips-head screws.

6.Repeat steps 3 through 5 to install the rails and rack adapters on the opposite side of the computer.

12 Dell PowerEdge4x00 and 6x00 SystemsRack Installation Guide