Dell E6400 XFR service manual Wi-Fi Sniffer Card, Replacing the SIM Card Assembly

Dell™ Latitude™ E6400 XFR Service Manual

3.Detach the tape and SIM card extension cable from the original SIM slot located on the left side of the battery bay, and place it out of the way.

4.Detach the Wi-Fi sniffer cable from the system board.

5.Using a scribe, gently place the edge under the SIM board and pry up.

NOTE: Light force may be required as this board is taped to the base.

6.Lift the SIM card slot up at an angle and remove it.

	2
1	3

1 Original SIM card slot 2 Wi-Fi sniffer cable connection

3SIM card board

29.2Replacing the SIM Card Assembly

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

1.Remove the tape backing from the bottom of the SIM card assembly.

2.Insert the SIM card slot at a slight angle to fit the connector into the base assembly. Use the alignment planes to seat into position. The back of the board should fit against the planes.

3.Route the SIM extension cable and reconnect the SIM extension board into the original SIM slot located in the battery bay.

4.Install the Wi-Fi sniffer cable to the system board.

5.Replace the palm rest, keyboard, palm rest overlay, led cover, display assembly, LCD cable channel covers and bottom access panel (see Replacing the Palm Rest).

6.Follow the procedures in After Working on Your Computer.

30 Wi-Fi Sniffer Card

30.1 Removing the Wi-Fi Sniffer Card

1.Follow the procedures in Before Working on Your Computer. Page 58