Dell E6400 XFR service manual Removing the DC Power Cable

Dell™ Latitude™ E6400 XFR Service Manual

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

1.Place the RJ-11 modem connector into the base assembly, aligning the guides on the connector sides with the base. Once installed, press down firmly on top of the RJ-11 connector to seal the adhesive to the base.

2.Replace the modem (see Replacing the Modem).

3.Replace the palm rest, keyboard, palm rest overlay, led cover, display assembly, LCD cable channel covers and bottom access panel (see Replacing the Palm Rest).

4.Follow the procedures in After Working on Your Computer.

1

2

4

3

1	I/O card	2	RJ-11 modem card
3	M2.5 x 5-mm screw	4	Modem connector

33 DC Power Cable

33.1 Removing the DC Power Cable

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

1.Follow the instructions in Before Working on Your Computer.

2.Remove the system board (see Removing the System Board Assembly).

NOTE: Do not remove the mini-pci wireless or FCM cards, memory modules, or processor from the system board.

3.Unroute the DC power cable from the base assembly. Pry up the DC power connector to release the double- stick adhesive tape on the bottom of the connector, and then lift the DC power connector out of the base assembly.

1

2

1 DC power connector 2 DC cable

Page 61