Dell E6400 XFR service manual Removing the Handle

Dell™ Latitude™ E6400 XFR Service Manual

35.2 Replacing the Stylus

1.Pinch the end of the tether loop to a point.

2.Place the tether loop, pointed end first, through the tether anchor at the edge of the system.

3.Run the stylus and tether through the tether loop.

4.Once the stylus and tether are completely through the tether loop, pull the stylus to secure the tether loop onto the tether anchor.

5.Insert stylus in stylus bay of the handle

6.Follow the procedures in After Working on Your Computer.

36 Handle

36.1 Removing the Handle

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

1.Follow the procedures in Before Working on Your Computer.

2.Remove the six M2.5 x 8-mm screws from the front of the palm rest.

3.Turn the system over and remove the four M2.5 x 8-mm palm rest retainer screws.

4.Place a scribe against the handle socket on the side, press in 1 inch and rotate to the front to lift the palm rest area slightly.

Page 63