3.Perform the following steps:
a.Unroute the display cables and antennas from the routing channels. [1]
b.Disconnect the antennas from the modules.
c.Remove the screws that secure the display connector cable cover to the system board. [2][3]
d.Disconnect the display connector cable from the system board. [4]
Figure 31.
4.Perform the following steps:
a.Remove the screws indicated to remove the hinge covers. [1]
b.Lift the hinge covers and remove them to expose the display cable routing and the display hinges underneath. [2]
c.Lift the cables to expose the display hinge screws. [3]
Figure 32.
48