3.3Media Configuration
The printer is equipped with a paper and label edge detector. The printer’s standard configuration is ‘Paper’ media. If you wish to use label media in your printer you will have to change the default settings:
Note: See section 4.1 for button and indicator functions.
1.Make sure that a roll of paper is loaded (not label). Turn the printer off by holding down the left button until both lights are off.
2.Simultaneously press both buttons for at least two seconds. The printer’s configuration is printed.
3.Answer Yes to modify the default setting
4.Answer No until you reach the Media section (press No 4 four times). Press Yes when Media is printed to enter that section.
5.Press No if ‘Paper’ is printed to change to ‘Labels’. When ‘Labels’ is printed press Yes.
6.Press No to skip the next section
7.Press Yes to save your modification. Your printer is now On Line and ready for label media to be loaded.
Warning: If your printer is configured for labels and if you have loaded paper, the label edge sensor will not detect the end of a label and will feed the paper endlessly. Unplug your printer to stop it. To correct this problem repeat the steps above and set the printer to ‘Paper’.
7 |