This completes the procedure to configure the network settings for the
Functions of the Network Controller Card
The
•Monitors frame power usage and sets the fan speed accordingly (higher power consumption requires higher fan speed for adequate cooling). The fans always run at maximum speed for 5 seconds after the fan door is closed, then adjust to the appropriate level based on power consumption.
•Monitors the frame door and
•Monitors the fan door and notifies the user if it is left open too long.
•Monitors the status of other cards in the frame via the internal bus.
•Generates alarms if any of the monitored functions develop errors.
•Provides an Ethernet connection to allow remote monitoring and control of the frame.
Controls and LEDs for the Network Controller Card
This section provides information on the controls and LEDs for the
Figure 13. MFC-8310-N DIP Switches
The LED indicators and controls for fan, alarm, and communication activity are shown in the following figure.
Page 32 | 8310/8321 User Manual • (V 1.0) |