Cooling Features
The 8321 series frames come standard with the Cooling Fan Module installed as original equipment from the factory. However, if you need to replace the ventilation in a 8321 series frame door, the optional
Cooling Fan Functions and User Controls
The 8321 series frames includes Fault LEDs and the Alarm mute button on the front of the frame door. For details on the LED functions, refer to Table 2.2. For operational details for your MFC- 8300 series controller card, refer to the
Figure 4.5 8321 Series Frame Door Features
Replacing the CFM-8321 Cooling Fan Module
This section includes instructions on installing the
Use the following procedure to replace the
1.Carefully remove the door from the frame as follows:
•Gently pull the side door tabs towards the center of the door, releasing the door from the frame. The door extender arms prevent the door from falling.
•Using both hands, pull the door towards you.
•Tilt the door upward until the arms match the cutout.
•Gently push the door extender arms in and over the retaining bolts and unhook from the frame.
2.Remove the door and place it on a clean, flat,
3.On the new frame door of the
This completes the procedure for replacing the
8310/8321 User Manual • (V 1.0) | Page 41 |