CNet Technology CNIG904S manual LAN Configuration, Data LAN Screen, IP Address, Network Mask

Page 14

CNet Technology Inc

Configuration

LAN Screen

The LAN screen, like the example below, will be displayed when you first connect.

Figure 5: LAN Screen

LAN Configuration.

For most users, the default values for these fields should be satisfactory, and no changes will be required.

If your LAN contains an existing Router or Routers, refer to Chapter 6 - Routing.

Data – LAN Screen

TCP/IP

IP Address	IP address for the Broadband Router. Use the default value of
	192.168.0.1 unless the address is already in use or your LAN is using a
	different IP address range. In the latter case, enter an unused IP Ad-
	dress from within the range used by your LAN.

Network Mask	The default value 255.255.255.0 is standard for small (class "C")
	networks. For other networks, use the Network Mask for the LAN
	segment to which the Broadband Router is attached. i.e. the same value
	as the PCs on that LAN segment.

Image 14

Contents Shared Broadband Internet Access User’s GuideTable of Contents Overview General Problems Internet Access Broadband RouterIntroduction Broadband Router FeaturesLAN Features Security Features Internet Access FeaturesConfiguration & Management Advanced Internet FunctionsPackage Contents Rear Panel Physical DetailsTop Mounted LEDs DIP Switch Setting Description DIP SwitchesRestore Default IP Address and Clear Password Choose an Installation Site InstallationInstallation Procedure RequirementsCheck the LEDs Power UpConnect Adsl or Cable Modem To Do this Refer to ConfigurationOverview Preparation Configuration ProgramConnecting to the Broadband Router If you cant connect Navigation & Data InputData LAN Screen LAN ConfigurationLAN Screen IP AddressRouting Table Dhcp ServerDNS Domain Name Server Tip WAN ConfigurationWAN Direct Connection Data WAN Direct ConnectionIP Address ButtonsAccount WAN PPPoEData WAN PPPoE OptionsData WAN StatusWAN Status Direct Connection WAN StatusConnection Log WAN Status PPPoEStatus Data Connection Log Messages Message DescriptionDevice LAN/Device StatusData LAN/Device Status LAN PortStatus To check your PCs TCP/IP Settings PC ConfigurationTCP/IP Settings Using Dhcp Using Specify an IP AddressDNS Tab Win 95/98 Internet Access Configuration Accessing AOLMacintosh Configuration Chapter Using the Broadband Routers Dhcp ServerUsing another Dhcp Server What Dhcp DoesTo Configure your PCs to use Dhcp Routing Broadband Router ConfigurationUsing this Screen Gateway Routing Table DataDestination InterfaceLocal Router Router ConfigurationRouting Example Other Routers on the Local LANFor the Broadband Routers Routing Table For Router As Default RouteFor Router Bs Default Route Entry 1 SegmentDevice Options PasswordWhen prompted for the password, leave the User Name blank To connect from a remote PC via the Internet NAT Network Address TranslationRemote Management Advanced Internet Advanced Internet ScreenSpecial Applications Screen Using a Special ApplicationSpecial Internet Applications At any time, only one 1 PC can use each Special ApplicationConfiguration Data from Service Provider IP Address seen by Internet Users Virtual ServersRemote PC Types of Virtual ServersType Virtual Server ConfigurationWAN IP Address LAN IP AddressTo Delete a defined Server User Defined Virtual ServersTo Modify Edit a defined Server To List all ServersConnecting to the Virtual Servers DetailsConfiguring the DMZ DMZ ScreenFeature EnableEnable DMZ DataAccess Control To use this featureOperations To Change Access for an Existing GroupSecurity Groups To Define a Security GroupAccess Rights Internet Access for this Group Packet Filter TableTo Delete an Existing PC PCsTo Add a New PC To Change an Existing PCs DetailsFilters Port No TCP PacketsTCP Filters UDP FiltersTroubleshooting General ProblemsInternet Access Specifications Broadband Router