(9) Specifying/ Canceling Underline (ESC - n)
Code: [1B]h + [2D]h + n
*{0 is less than or equal to n is less than or equal to 02} Data is described in Hex code. Specifying/canceling an underline.
•An underline is attached to the full character width. It is, however, not attached to the part having been horizontal tab command.
•An underline is not attached to a 90º -
•Types of underlines by n value are shown below:
n (Hex) | Type |
0Canceling an underline.
1Specifying an underline for
2Specifying an underline for
(10)Specifying 1/6 inch line feed rate (ESC 2)
Code : [1B]h + [32]h
The line feed rate per line is specified by 1/6 inch.
(11) Setting line feed rate n/203 inch (ESC 3 n)
Code : [1B]h + [33]h + n
*{0 is less than or equal to n is less than or equal to FF} Data is described in Hex code. The line feed rate per line is specified by n/156 inch.
•The initial value is n = 26(18H), being 4.23 mm line feed rate.
(12)Initializing Printer (ESC @)
Code : [1B]h + [40]h
Clears data stored in the print buffer and brings various settings to the initial state (Default state).
•Data inside the internal input buffer are not cleared.
•Dip switches are read once again.
(13)Setting Horizontal Tab Position (ESC D n NUL)
Code : [1B]h + [44]h + n [00]h
*{0 is less than or equal to n is less than or equal to FF} Data is described in Hex code. Specifying a horizontal tab position.
•"n" indicates the no. of columns from the beginning to the horizontal tab position. At this time, n= set position
•The tab position is set at position where it is "character width x n" from the line beginning. The character width, at this time, includes the rightward space amount. In double wide characters, it is made double of the ordinary case.
•Tab positions can be specified are maximum 24. Specifying exceeding this is ignored.
•ESC D NUL clears all the set tab positions. Following clearing, horizontal tab command is ignored.
•Initial value is specified for each eight characters(9.17.25.33.41) of ANK characters.