Citizen Systems CMP-10BT user manual Communication by Bluetooth

Page 27

4.5 Communication by Bluetooth

For the Bluetooth communication, it is necessary to choose CMP-10BT and set the DIP switches for Bluetooth.

As built-in Bluetooth module supports Serial Port Profile, host machine needs to communicate with CMP-10BT based on serial port profile. Please refer to the software manual of the host machine for the details. When CMP-10BT connects through the Bluetooth interface, the host machine may require a pin code. The last 4 characters of the Bluetooth Address that prints on the printer self test are the pin code that should be entered in to the host machine.

4.6 Reading Mag Stripe Card (Only Model with Built-in Mag Stripe Card Reader)

To read the mag stripe card, it is necessary to send a special command to the printer.

For the command, refer to Command Reference supplied separately. If mag stripe card command is entered, Power LED lights red.

While the Power LED continues to light for 10 seconds, swipe the card be read during that time.

If 10 seconds has passed or reading is completed, the printer returns to normal mode.

Slide the card with the magstriped surface down to pass the magstripe over the reader part.

When reading has completed, buzzer sounds momentarily and Power LED changes to green.

— 25 —

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Mobile Thermal Printer Declaration of Conformity General Precautions Definition of Pictogram About PictogramPrecautions in Handling Printer Precautions on Using Printer Precautions on Using Battery Precautions on Setting Print Paper Precautions on Using Thermal Paper Print Paper Precautions on Using AC Adapter Precautions on Using Special Serial CableTable of Contents List of Commands Maintenance and Service Appendix Introduction FeaturesType Classification Included and Optional AccessoriesFeature Parameters General SpecificationsFeature Parameters Feature Parameters Explanation of Printer Parts LED IndicatorsCommunication Port and Switch Buzzer Inside of Paper CoverBottom Surface and Battery Cover Dimensions and Views Replacing the Paper Roll OperationMethod of Charging Communication by IrDA Communication Via Serial Port Cable Communication by Bluetooth Removing the Battery Pack Installing the Battery Pack DIP Switch Setting Setup menu function Firmware after Ver 2.20EN List of choice in the setup menu Interface Selection Auto Power OFFLow Battery Detection FunctionSelf Testing and Internal Settings Monitoring the Print Head OverheatingPrint Area BEL List of CommandsGS H Maintenance and Service How to Mount Belt Clip Appendix Handling Belt Clip KITMounting Rubber Feet Memo Weee Mark
Top Page Image Contents