Citizen Systems CMP-10BT user manual Setup menu function Firmware after Ver 2.20EN

Page 31

4.10 Setup menu function (Firmware after Ver 2.20EN)

Make sure the printer power is off. Press ON/OFF switch and keep pressed for about 5 seconds until .LED is changed to red and leave the switch. Then buzzer beeps and printer prints current setting and goes to setup menu as follows.

Example

DISCOVERABILITY:	YES
PAIRING INFO SAVING:	YES
MEMORY SWITCHES:	00000000
BAUD RATE:	9600
POWER OFF TIME:	10 min
PRINT DENSITY:	100%

MAX IrDA SPEED 57600: NO

SETUP MENU <ON/OFF> - NO, <LF> - YES

CHANGE DISCOVERABILITY ?

The setting can be done by choosing NO (ON/OFF switch) or YES (LF switch) against coming up questions .

During the menu setting, if YES is chosen somewhere, following question comes up at the end of setup menu

SAVE SETTINGS ?

If you want to save the changed setting, choose YES here and if not, choose NO.

If YES is not chosen, the new setting will not be effective.

Setup menu ends with Power off in any case.

— 29 —

Image 31

Contents Mobile Thermal Printer Declaration of Conformity General Precautions Definition of Pictogram About PictogramPrecautions in Handling Printer Precautions on Using Printer Precautions on Using Battery Precautions on Setting Print Paper Precautions on Using Thermal Paper Print Paper Precautions on Using AC Adapter Precautions on Using Special Serial CableTable of Contents List of Commands Maintenance and Service Appendix Introduction FeaturesType Classification Included and Optional AccessoriesFeature Parameters General SpecificationsFeature Parameters Feature Parameters Explanation of Printer Parts LED IndicatorsCommunication Port and Switch Buzzer Inside of Paper CoverBottom Surface and Battery Cover Dimensions and Views Replacing the Paper Roll OperationMethod of Charging Communication by IrDA Communication Via Serial Port Cable Communication by Bluetooth Removing the Battery Pack Installing the Battery Pack DIP Switch Setting Setup menu function Firmware after Ver 2.20EN List of choice in the setup menu Interface Selection Auto Power OFFLow Battery Detection FunctionMonitoring the Print Head Overheating Self Testing and Internal SettingsPrint Area BEL List of CommandsGS H Maintenance and Service Appendix Handling Belt Clip KIT How to Mount Belt ClipMounting Rubber Feet Memo Weee Mark