Citizen Systems CMP-10BT user manual Appendix Handling Belt Clip KIT, How to Mount Belt Clip

Page 38

8. APPENDIX HANDLING BELT CLIP KIT

This kit consists of a belt clip, two screws, and two rubber feet.

8.1 How to Mount Belt Clip

Mount the belt clip in the square frame using the two screws supplied. The direction of the belt clip should be as per the drawing below.

Note: Do not use screws without mounting the belt clip. The screws when mounted alone reach too deep and may come in contact with the internal circuit board and cause a failure.

8.2 Mounting Rubber Feet

Confirm that the grooves for the rubber feet are clean and neither dust nor oil is present on the grooves for rubber feet.

Peel off the liner sheet of the adhesive seal for rubber foot and carefully fit the rubber foot to the groove. Press and hold to secure the rubber foot.

Belt clip

Grooves for rubber feet

— 36 —

Image 38

Contents Mobile Thermal Printer Declaration of Conformity General Precautions About Pictogram Definition of PictogramPrecautions in Handling Printer Precautions on Using Printer Precautions on Using Battery Precautions on Setting Print Paper Precautions on Using Thermal Paper Print Paper Precautions on Using Special Serial Cable Precautions on Using AC AdapterTable of Contents List of Commands Maintenance and Service Appendix Features IntroductionIncluded and Optional Accessories Type ClassificationGeneral Specifications Feature ParametersFeature Parameters Feature Parameters LED Indicators Explanation of Printer PartsCommunication Port and Switch Inside of Paper Cover BuzzerBottom Surface and Battery Cover Dimensions and Views Operation Replacing the Paper RollMethod of Charging Communication by IrDA Communication Via Serial Port Cable Communication by Bluetooth Removing the Battery Pack Installing the Battery Pack DIP Switch Setting Setup menu function Firmware after Ver 2.20EN List of choice in the setup menu Function Auto Power OFFLow Battery Detection Interface SelectionPrint Area Self Testing and Internal SettingsMonitoring the Print Head Overheating List of Commands BELGS H Maintenance and Service Mounting Rubber Feet How to Mount Belt ClipAppendix Handling Belt Clip KIT Memo Weee Mark