Citizen Systems CBM-910 Type II user manual Memory Switch Setting, Japan 910JPN

Page 23

4.6 Memory Switch Setting

<Memory Switch Initial Setting>

 

Japan (910JPN)

International character selection

Japanese

Code page

910-compatible (Japan)

Emulation

CBM910

Ack timing

After

Paper-near-end selection

Valid

SEL/DESEL at power ON

SEL

Busy signal clear timing

Standard

Buffer Size (Serial I/F)

2k bytes

Memory switch can be changed by a command or by manual operation.

a)Change by command

Memory switch can be changed by a command. For details, refer to 8. Print Control Function.

When the printer receives the command, it outputs a BUSY signal and enters memory setting mode. After writing into memory switch, software resetting is carried out and the receive buffer/print buffer are cleared causing each set value to return to the initial value and then the contents of the memory switch(es) are reloaded.

b)Change by manual operation

Turn the printer power on with DIP switch No. 4 set to ON and by pressing and holding the SEL switch. The printer prints the information on the current memory switch setting and then enters the Change Setting mode.

In this case, the POWER lamp blinks at 1-second intervals while the SEL lamp is kept turned off and BUSY signal outputted.

Using the SEL switch and LF switch, choose one of the options for each setting item. Then memory switch can be set or changed. Setting items and options are printed each time the switch is pressed.

The SEL switch allows the option being printed to be determined as the set value for current setting item, advancing to the next option item. The LF switch allows the option currently being printed to be deselected among the same setting items and the next option item to be printed.

To fix the value set by the memory switch when the option item of the last setting items is selected, press the SEL switch. To restart setting from the first setting items, press the LF switch.

NOTE

Before turning the printer power on, restore the DIP switch No. 4 to the former position.

— 19 —

Image 23
Contents DOT Matrix Printer Weee Mark Page Declaration of Conformity General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Introduction FeaturesAccessories AC Adapter TypeCBM-910II-24 CBM-910II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsOFF Part DescriptionsConnection of the AC Adapter OperationsSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Japan 910JPN Memory Switch SettingUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Parallel Interface Connector Pin AssignmentPin Signal Name Description of Input/Output Signals Electrical Characteristics Serial Interface Host-Printer Pin Signal Name Signal Direction Function RS-232CDTR Data Terminal Ready Description of Input/Output SignalTTL circuit Input Reset Receiving Control and Buffering Error DetectionSwitch No Parity Baud Rate Factory Setting DIP Switch SettingSwitch No Function Factory SettingParallel Interface Type List of Control Codes Symbol Code Function CBM910 IDP3110 HexadecimalPrint Control Function Control Code Details Abcd Page Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Ascii + 910 Emulation International 910 Emulation Japan Character Code TableCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page
Related manuals
Manual 62 pages 43.41 Kb