Citizen Systems CBM-910 Type II user manual

Page 40

(4)Inverted Letter Assignment (DC2) Command

When data are input with DC2 (12H) attached at the beginning of a line (invalid when attached to any other place), data following are all printed in inverted letters. To cancel this, input either DC2 again or DC1 (initial setting.)

(5)Initial Setting (DC1) Command

With DC1 (11H) input, various conditions set after power supply are cancelled and the state as at supply of power is restored.

Content of the input buffer, however, is held unchanged.

(6)Power Down Function (DC2, DC3) Only when 3110 emulation is selected

In order to reduce power consumption when printer is waiting for the operation, 2 power down modes triggered by the codes DC2 and DC3 are incorporated into this product. When the printer receives power down commands (DC2 or DC3), it switches to the power down mode after all entered data is printed out.

a)DC2 (12H)

Unit switches to power down mode when DC2 code is entered. Operation of the oscillator is not terminated.

[Power down release] (a-1) RESET input

By applying “LOW” pulse to the RESET terminal for more than 4 ms, the power down mode is cleared, thereby switching the unit to operational condition approximately 500 ms after initialization.

b)DC3 (13H)

Unit switches to power down mode when DC3 code is entered.

Operation of the oscillator is terminated, reducing the power consumption to less than that of the DC2 power down mode.

(b-1) RESET input

By applying “LOW” pulse to the RESET terminal for more than 4 ms, the power down mode is cleared, thereby in HIGH-level switching the unit to operational condition approximately 500 ms after initialization.

— 36 —

Image 40
Contents DOT Matrix Printer Weee Mark Page Declaration of Conformity General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Accessories FeaturesIntroduction Type AC AdapterSpecifications CBM-910II-24 CBM-910II-40External Appearance and Part Descriptions External AppearancePart Descriptions OFFOperations Connection of the AC AdapterSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Memory Switch Setting Japan 910JPNUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Pin Signal Name Connector Pin AssignmentParallel Interface Description of Input/Output Signals Electrical Characteristics Serial Interface Pin Signal Name Signal Direction Function RS-232C Host-PrinterDescription of Input/Output Signal DTR Data Terminal ReadyTTL circuit Input Reset Error Detection Receiving Control and BufferingDIP Switch Setting Switch No FunctionFactory Setting Switch No Parity Baud Rate Factory SettingParallel Interface Type Print Control Function Symbol Code Function CBM910 IDP3110 HexadecimalList of Control Codes Control Code Details Abcd Page Country Character Code TableESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Character Code Table Ascii + 910 Emulation International 910 Emulation JapanCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page
Related manuals
Manual 62 pages 43.41 Kb