Citizen Systems CBM-910 Type II user manual Ff Ff Ff Ff Ff Ff

Page 44

[Method of data transmission] d-1) Single character registration

Select the address to be defined (character code) from among 20H to FFH and designate is as A1. When registering a single character, starting and ending addresses match each other. That is, A1=A2.

<Example>

A 6 6 dot matrix full dot pattern is to be registered in address 41H (code for the fixed character “A”. (Numerals are hexadecimal.) ESC + “&” + A1 + A2 + “Pattern data (6 bytes)”

1B

36

41 41

FF FF FF FF FF FF

In the successive controls, a 6 8 dot matrix full dot is output whenever the character code 41H is specified. (Character “A” cannot be accessed.)

d-2) Multiple character registration

By repeating the single character registration, a maximum of 8 characters can be registered. When defining multiple characters in a successive address (character code), register pattern data for a maximum of 8 characters by designation A1 as the starting address and A2 as the ending address.

Note: A1 < A2, A2 – A1 7

[Pattern data configuration] (For 24-column model)

Pattern data to be registered must consist of 6 bytes per character. That is, pattern data configured by a 6 8 dot matrix is broken up into 6 vertically positioned units each of which is represented by 1 byte of data. All together, 6 bytes of data are transmitted.

<Example> When transmitting the following data:

1 2 3 4 5 6

0

1

2

3

4

5

6

7

1

2

3

4

5

6

[Printing of registered letters]

To print registered character, in the same manner as printing other fixed characters, use the commands (CR, LF, ESC + B + n).

— 40 —

Image 44
Contents DOT Matrix Printer Weee Mark Page Declaration of Conformity General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Introduction FeaturesAccessories Type AC AdapterSpecifications CBM-910II-24 CBM-910II-40External Appearance and Part Descriptions External AppearancePart Descriptions OFFOperations Connection of the AC AdapterSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Memory Switch Setting Japan 910JPNUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Parallel Interface Connector Pin AssignmentPin Signal Name Description of Input/Output Signals Electrical Characteristics Serial Interface Pin Signal Name Signal Direction Function RS-232C Host-PrinterDescription of Input/Output Signal DTR Data Terminal ReadyTTL circuit Input Reset Error Detection Receiving Control and BufferingDIP Switch Setting Switch No FunctionFactory Setting Switch No Parity Baud Rate Factory SettingParallel Interface Type List of Control Codes Symbol Code Function CBM910 IDP3110 HexadecimalPrint Control Function Control Code Details Abcd Page Country Character Code TableESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Character Code Table Ascii + 910 Emulation International 910 Emulation JapanCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page
Related manuals
Manual 62 pages 43.41 Kb