Citizen Systems CBM-910 Type II user manual

Page 47

(13)Registered Letter Valid/Invalid (ESC + “%” + n) Command

Whether a registered pattern is valid or invalid is set with ESC (1BH) + ”%” (25H) + n code being input.

n = 1 (01H): Registered pattern to be made valid.

(Addresses for which no registration change has been conducted are taken as inside fixed characters.)

n = 0 (00H): Registered pattern to be made invalid. (Taken as inside fixed character sets.)

With 910 emulation 40-digit version, to use the registered characters, it is necessary to set the registered characters to be valid using this command. With 3110 emulation and 910 emulation 24-digit version, the registered characters are valid at the registration of the user-defined characters without setting the registered characters to be valid.

To reset to the state where inside fixed characters are usable while registered characters are valid, it is necessary to disable the registered characters. Command for setting to invalid operates regardless of the emulation or number of digits.

Registered Characters Enable/Disable Command

Set to Valid

Set to Invalid

910 Emulation (40 digits)

O

O

910 Emulation (24 digits)

O

3110 Emulation (40 digits)

O

3110 Emulation (24 digits)

O

O: Operation enabled by the Valid/Invalid command of registered characters.

: As the registered characters are valid by the Register User-defined Character command, it is not necessary to set the registered characters to be valid.

— 43 —

Image 47
Contents DOT Matrix Printer Weee Mark Page Declaration of Conformity General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Introduction FeaturesAccessories AC Adapter TypeCBM-910II-24 CBM-910II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsOFF Part DescriptionsConnection of the AC Adapter OperationsSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Japan 910JPN Memory Switch SettingUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Parallel Interface Connector Pin AssignmentPin Signal Name Description of Input/Output Signals Electrical Characteristics Serial Interface Host-Printer Pin Signal Name Signal Direction Function RS-232CDTR Data Terminal Ready Description of Input/Output SignalTTL circuit Input Reset Receiving Control and Buffering Error DetectionSwitch No Parity Baud Rate Factory Setting DIP Switch SettingSwitch No Function Factory SettingParallel Interface Type List of Control Codes Symbol Code Function CBM910 IDP3110 HexadecimalPrint Control Function Control Code Details Abcd Page Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Ascii + 910 Emulation International 910 Emulation Japan Character Code TableCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page
Related manuals
Manual 62 pages 43.41 Kb