Citizen Systems iDP-3210 user manual Inserting the Paper Roll

Page 23

iDP-3210 User’s Manual

4.4 Inserting the Paper Roll

Cautions : Do not use a paper roll other than the one specified in this manual.

In case of using a paper roll other than the one specified, there is a case the print quality and reliability may not be guaranteed.

(1)Holding the projections on both sides of the printer cover, open it until it stops.

Cautions : The printer cover is not detachable. Do not try to further open beyond the stop position. Do not insert the paper roll with its end fluffed or bent.

(2)Cut the end of paper roll approximately at a right angle.

Cautions : Do not insert the paper roll with its end fluffed or bent.

Good

Good

Good

No Good

No Good

No Good

(3)Confirming winding direction of the paper roll, put it on the roller section of the upper cover.

(4)Turn ON the power switch.

(5)Insert the tip of the paper roll straight into the paper inlet (as indicated by an arrow on the case).

(6)Paper is automatically pulled into the platen roller and comes out of the paper outlet. As excessive portion of paper is automatically cut off, remove it away.

(7)With the printer cover closed, printer is ready to print.

CITIZEN

23

 

Image 23
Contents User’s Manual EMC LVDImportant Safety Instructions Citizen Citizen Citizen Precautions for installation Citizen Citizen Ordinary Maintenance Contents Power Supply Connector Specifications Print Control Function Unpacking FeaturesCitizen Model Classification Basic SpecificationsCode 39, Code 128, Codabar Basic SpecificationsRecommended Paper Printing Paper SpecificationsPrinting position Head and Cutter Layout Outer Appearance and Components Operation Connecting AC AdapterConnecting Interface Cable Connecting Drawer Kickout Connector Inserting the Paper Roll Citizen Removing Paper Jam How to Remove Remaining Roll PaperCitizen Canceling Cutter Lock Cleaning Print Head Operation Panel and Display of Error Roller portion of the upper cover works Location of Dip Switch Dip Switch SettingDip Switch Setting Parallel Interface STB ResetFault DataElectrical Characteristics TYP MINSerial Interface DSR Signal Name FunctionDTR 3 I/O Signals Data Configuration Error Detection Electrical Characteristics Drive Circuit SpecificationsConnector’s Pin Configurations Power Supply Connector Specifications ESC = Command ListESC SP Horizontal Tab Command HT Code 09h Command DetailsBIT Function Value Citizen DPI Mode NO. of Dots DOT DensityVertical Direction Horizontal Direction Citizen Citizen Character SET Paper feed SW valid Paper end With paper Without paper Specifying inverted characters Specifying 90 -right- turned Characters UPC-A UPC-E JAN13 EAN JAN 8 EAN Code ITF Codabar Mode Name DOT Density This action is repeated n1 times Position International IBM Character #2 Character Code TableInternational Character Code Table 1Outler Drawing of Printer Model iDP-3210 Appendix 1 Outline Drawing2Outer Drawing of AC Adapter Model 30AD Appendix 2 Block Diagram