Citizen Systems iDP-3210 user manual Specifications, Connector’s Pin Configurations, Drive Circuit

Page 43

iDP-3210 User’s Manual

7. Drawer Kickout Connector

7.1Specifications

(1)Drawer-Kick Drive Signal

Pulses specified by ESCp are output. Also, SW(+) state, in parallel interface, can be observed by Pin 34 of the interface connector and, in serial interface, by ESC u command.

(2)Electrical Characteristics

1)	Drive voltage	:	DC24V
2)	Drive current	: Max. 0.8A (within 510ms)
3)	SW signal	:	signal level "L"= 0 - 0.5V
			"H"= 3 - 5V

7.2 Connector’s Pin Configurations

No.	SIGNAL NAME	FUNCTION
1	FG	Frame ground
2	DRAWER 1	Drawer 1 driving signal
3	DRSW	Drawer SW input
4	VDR	Drawer driving power supply
5	DRAWER 2	Drawer 2 driving signal
6	GND	Common ground on the circuits

Connector used : TM5RJ3-66 (Hirose) or equivalent

Applicable connector : TM3P-66P (Hirose) or equivalent

Caution

1)No output is available during printing.

2)Drawer 1 and Drawer 2 can not be driven simultaneously.

3)Use a solenoid of 36 Ohm or more for the drawer. Do not exceed 0.8A for output current. Failure or seizure can take place.

4)No connection is available to a to a telephone line.

7.3Drive Circuit

CITIZEN	43

Image 43

Contents User’s Manual EMC LVDImportant Safety Instructions Citizen Citizen Citizen Precautions for installation Citizen Citizen Ordinary Maintenance Contents Power Supply Connector Specifications Print Control Function Unpacking FeaturesCitizen Model Classification Basic SpecificationsCode 39, Code 128, Codabar Basic SpecificationsRecommended Paper Printing Paper SpecificationsPrinting position Head and Cutter Layout Outer Appearance and Components Operation Connecting AC AdapterConnecting Interface Cable Connecting Drawer Kickout Connector Inserting the Paper Roll Citizen Removing Paper Jam How to Remove Remaining Roll PaperCitizen Canceling Cutter Lock Cleaning Print Head Operation Panel and Display of Error Roller portion of the upper cover works Location of Dip Switch Dip Switch SettingDip Switch Setting Parallel Interface STB ResetFault DataElectrical Characteristics TYP MINSerial Interface DTR Signal Name FunctionDSR 3 I/O Signals Data Configuration Error Detection Electrical Characteristics Connector’s Pin Configurations SpecificationsDrive Circuit Power Supply Connector Specifications ESC SP Command ListESC = Horizontal Tab Command HT Code 09h Command DetailsBIT Function Value Citizen Vertical Direction Horizontal Direction Mode NO. of Dots DOT DensityDPI Citizen Citizen Character SET Paper feed SW valid Paper end With paper Without paper Specifying inverted characters Specifying 90 -right- turned Characters UPC-A UPC-E JAN13 EAN JAN 8 EAN Code ITF Codabar Mode Name DOT Density This action is repeated n1 times Position International IBM Character #2 Character Code TableInternational Character Code Table 1Outler Drawing of Printer Model iDP-3210 Appendix 1 Outline Drawing2Outer Drawing of AC Adapter Model 30AD Appendix 2 Block Diagram