iDP3110 User's Manual
As this printer prints out 4 dot lines as one unit, the lacking data is output as space once the data for 4 dot lines are read in or the output of data specified in n1, n2 and n3 has finished.
Note 1) If n1 = 23 is specified in
Note 2) Although the printer returns to text mode when bit image mode printout is completed, line spacing is set to 0 to enable further output in the bit image mode. Line feed is required in order to commence text mode output.
For bit image printing, inverted printing is not performed but normal printing, even if the DIP switch 1 is set to “ON”.
c)International character setting (ESC + R + n)
By entering the code ESC + R + n, characters input hereafter are set to the characters for the following countries.
Then n value and country setting is as indicated in the table below.
n | Country | n | Country |
|
|
|
|
0 | America | 5 | Sweden |
|
|
|
|
1 | France | 6 | Italy |
|
|
|
|
2 | Germany | 7 | Spain |
|
|
|
|
3 | England | 8 | Japan |
|
|
|
|
4 | Denmark |
|
|
|
|
|
|
n other than that specified becomes invalid and the setting prior to the invalid specification is employed. When the printer is turned on or RESET, the country is set to n = 0 (America).
CITIZEN | 22 |