Print Control Function, Control Command

iDP3110 User's Manual

8. PRINT CONTROL FUNCTION

8.1 Control Command

(1)Print command (CR or LF)

In case of initiate parallel transmission, select code CR (0DH) or LF (0AH) on the DIP switch 2.

If the selected code (CR or LF) is input, the data in the print buffer is printed and line feed is performed. When the serial interface is used, only the CR code becomes effective.

When graphic (mosaic) printing is performed, line feed is not performed by the print command, and graphic (mosaic) printing is allowed on the next line.

(2)Input data cancel command (CAN)

By entering the CAN (18H) code, all data entered prior to the entry of the code on a same line is canceled.

(3)Enlarged character printing (SO)

By entering the SO (0EH) code on a specific digit, data entered there-after is output as enlarged characters. The function is cleared by entering the print code (CR or LF) or DC4 (14H).

The number of printable columns per line for an entire line of enlarged characters are indicated in the table below.

Model	Number of columns

iDP3110-24*	12 columns

iDP3110-40*	20 columns

CITIZEN