iDP3110 User's Manual
a)Line spacing setting command (ESC + A + n)
Dot line space setting is determined by entering the code ESC +A + n.
Initial setting is 2 dot line space. The n should be an even number in the range of 0 ≤ n ≤ 255. Note) If an old number is entered, the dot line is set to
Continuous printing is enabled by specifying n = 0 or 1.
b)Bit image printing (ESC + K + n1 + n2 + n3)
By entering ESC + K + n1 + n2 + n3, print mode is switched from the text mode to bit image mode. n1, n2, and n3 indicate the transmission volume of the bit image data to follow. That is, n1 indicates the horizontal byte while n2 and n3 signify the vertical dot lines.
(Relation between the data and printout)
(Range of parameter setting)
MODEL | n1 | n2 | n3 |
|
|
|
|
1 to 18 | 0 to 255 | 0 to 1 | |
|
|
|
|
1 to 23 | 0 to 255 | 0 to 1 | |
|
|
|
|
In case a number is beyond the specificable range is specified, and if n2 = n3 = 0 is specified, the bit image mode is canceled and the printer returns to text mode.
CITIZEN | 21 |