Citizen CLP-2001 user manual When fnnn command is executed while tear-off is OFF, Priority order

•Parameter initial values

Initial values of print and feed positions are described below.

				Unit:	mm (inch)
	Normal	Auto-	Peeling	Tear-off	Minimum
	printing	cutter			value
Print position	55.9	55.9	55.9	55.9	12.7
(Onnnn, form offset)	(2.2)	(2.2)	(2.2)	(2.2)	(0.5)
Feed position	55.9	*	*	70.1	12.7
(fnnn)	(2.2)			(2.8)	(0.5)

If values lower than the minimum values are set, initial values will be set instead. (For values with mark*, see the separate option operation manuals.)

6.5.6When "fnnn" command is executed while tear-off is OFF

Even with the tear-off ‘OFF,’ the paper will be fed to the "fnnn"-specified position after printing if an "fnnn > Onnnn" value is set by using the "fnnn" command.

This function will be used for such case as another device is incorporated in the printer.

To perform operation with the FARGO, the following may be different from those in the tear-off ‘ON’:

•The paper is fed immediately after printing, and in the tear-off ‘ON’ the paper is fed when no data is transmitted for 0.5 second after printing.

However, if the next print data is transmitted during printing, the printer will start the next printing without feeding or back-feeding.

6.5.7Priority order

The following three functions (optional) cannot be performed simultaneously.

If commands for these three functions are received simultaneously, they will be executed in the following priority order:

1st: Auto-cutter

2nd: Peeler

3rd: Tear-off

6-16