Citizen CLP-2001 user manual Outline of Command System, STX + L ↓ With printing Without printing

Page 69

6.3Outline of Command System

For details about command system, see the Command Reference separately available.

Commands for this printer consist of a string of ASCII codes and end with "CR" (decimal: 13, hex: 0D). Commands are generally classified into two types, system-level commands and label format commands.

System-level commands are used for system-level operations such as printer status output, sensor selection and memory card maintenance. On the other hand, label format commands are used for definition of printing contents such as character data, bar code data, printing speed, and print density.

System-level commands start with ASCII "SOH" or "STX." Commands starting with "SOH" are required for real-time execution. When received, they are executed immediately even during printing. Commands starting with "STX" enter the buffer area once and then are executed in the order of data reception.

Label format commands end with "CR", following the system-level commands "STX" + "L."

System-level commands start with "SOH" or "STX"

Commands to start with "SOH"

Executed immediately after receiving data (e.g. printing stop, printer status output etc.)

Commands to start with "STX"

Executed in sequence after inputting into the receive buffer

(e.g. sensor switching, memory card maintenance etc.)

"STX" + "L"

"E" (with printing)

 

 

"X" (without printing)

Label format commands end with "CR"

Print parameter control

Character data definition commands

Bar code definition commands

Graphic commands

Other commands

6-11

Image 69
Contents CLP-2001 Page FCC Compliance Statement For American Users EMI Compliance Statement For Canadian Users Important Safety Instructions Page Safety Signs Page General precautions Precautions when installing the printer Chapters in this manual Table of Contents Options Xii Chapter Setup Confirmation of Carton Contents Installing the Paper Holders Front view Names and Functions of the PartsInside view Page Side view Connection to Power Connection to a Computer Page Chapter Control Panel Control Panel Normal Operating Mode LCD/LED Indications and Adjustment ControlsSelf-Test Mode Printer Setup ModeSystem Maintenance Mode Page Chapter Paper Ribbon Kinds of Paper Label and Tag SpecificationsPage Page Units for specifying position and length Reference points RibbonLoading the Paper Reference Plane Positioning Notch Loading the Ribbon Print Head Offset Adjustments Page Ribbon width Ribbon winding Ribbon feed Tension Section Ribbon Tension AdjustmentsChapter Troubleshooting Error descriptions and indications Error MessagesCmnd Error indications and corrective actions Page Page Power Troubleshooting Paper Feed Troubleshooting Ribbon Feed Troubleshooting Print Troubleshooting Interface Troubleshooting Page Chapter Options Adjustable Sensor Auto-Cutter UnitPeeler Unit Pcmcia Memory Card 8-in Size Roll Paper Holder Chapter Specifications ITF14 ITF16 Basic SpecificationsPage LCD Interface Serial interface specificationsParallel interface specifications 4 RS-232C protocol 3 RS-232C loopback testPage Interface pin assignment Parallel interface pin assignment table STX + L ↓ With printing Without printing Outline of Command SystemExample of Connection to a Computer Tear-off when printing Tear-Off FunctionTurning Tear ON/OFF Paper is fed to the tear position Tear-off when feedingTear-off and type of data Cut position adjustmentsPriority order When fnnn command is executed while tear-off is OFF