Carrier D2-3466-2 instruction manual

Page 5

ATTENTION: When connected to a non-regenerative common DC bus, regeneration may cause a rise in DC bus voltage. Be aware that other drives on the bus may experience an unexpected

!speed increase due to the high bus voltage. Failure to observe this precaution may result in bodily injury.

ATTENTION: The motor shaft can rotate in either direction by up to one (1) revolution, providing minimum torque immediately after the identification procedure (initiated in H.020) has been started. Stay clear of rotating machinery. Failure to observe this precaution could result in bodily injury.

ATTENTION: In V/Hz regulation, if P.000 (Control Source) is set to OP (Option Port), and P.062 is set to 1 (Hold Last Reference), and the drive loses communication with the network, the drive will maintain the last frequency command sent to it. Ensure that driven machinery, all drive-train mechanisms, and application material are capable of safe operation at the maximum operating speed of the drive. Failure to observe this precaution could result in bodily injury.

ATTENTION: Carrier Frequency (P.047) and Current Limit (P.005) must be set correctly before activating the identification procedure (H.020) to avoid motor overloading and/or overheating. Failure to observe this precaution could result in damage to, or destruction of, the equipment.

ATTENTION: The motor can rotate in the reverse direction during the identification procedure (H.020) even if reverse disable has been selected in P.027. Uncouple the motor from any driven machinery that could be damaged by reverse rotation. Failure to observe this precaution could result in damage to, or destruction of, the equipment.

Image 5
Contents Carrier VFD Quick Reference Page Page Page Page Page Contents Carrier VFD Quick Reference Getting Assistance from Reliance Electric Required PublicationsCarrier VFD Quick Reference Replace with 2.fm 11 X 17 Z-fold Carrier VFD Quick Reference Monitor Mode Carrier VFD Quick Reference For Carrier Drives Carrier VFD Quick Reference Record the following nameplate information Record the following job informationCarrier VFD Quick Reference Verifying That DC Bus Capacitors Are Discharged Test Equipment Needed To TroubleshootPOS NEG TP1 TP2 Initial DC Bus Checking the Power Modules and Motor with Input Power Off Igbt Alarm Codes Troubleshooting the Drive Using Error CodesFault Codes Error LogAlarm Code Description Alarm Cause Corrective Action Identifying Alarm Codes and RecoveringFault Code Description Fault Cause Corrective Action Identifying Fault Codes and RecoveringIPL OPL Slow Ramp Rate of DC Bus DC Input Ground Fault ExcessiveAsymmetrical Bus When Carrier VFD Quick Reference Troubleshooting the Drive Code Fault Description Fault Cause Corrective Action Identifying Fatal Fault Codes and RecoveringStatus of LEDs Fault Description Corrective Action Indentifying PMC Board Fault Codes and RecoveringResetting a Checksum CHS Fault Model Amps Code Number Technical Writing Internal Use DIFPage Page Publication D2-3466-2 May 2005 -- Supercedes D2-3466-1 June