Carrier D2-3466-2 instruction manual Model Amps Code Number

Page 34

Step 8. Press UP ARROW until P.048 is displayed.

Step 9. Press ENTER.

Step 10. Press UP or DOWN ARROW to select UEC or U-H mode.

Step 11. Press ENTER. Observe SELF is displayed briefly.

Step 12. Press UP or DOWN ARROW until P.006 is displayed.

Step 13. Press ENTER.

Step 14. Press UP ARROW until 75 is displayed.

Step 15. Press ENTER.

Step 16. Press UP ARROW until R998 is displayed.

Step 17. Press ENTER.

Step 18. Press UP ARROW until ON is displayed.

Step 19. Press ENTER.

Step 20. Press UP ARROW until P.999 is displayed. Depending on software version, the display may show PUGH or P.999.

If PUCH is displayed, wait for 0 to display. The procedure is complete.

If P.999 is displayed, continue with step 21.

Step 21. Press ENTER.

Step 22. Press UP ARROW until the correct power unit current and voltage rating code appears. The codes are as follows:

Model	Amps	Code
Number
41LR4060	414	41.4
50LR4060	500	50.4
64LR4060	643	64.4

Step 23. Press ENTER. PUCH should appear briefly.

The drive is ready to operate. If in vector mode, enter the correct values for U parameters and perform SELF TUNING.

6-16	Carrier VFD Quick Reference

Image 34

Contents Carrier VFD Quick Reference Page Page Page Page Page Contents Carrier VFD Quick Reference Required Publications Getting Assistance from Reliance ElectricCarrier VFD Quick Reference Replace with 2.fm 11 X 17 Z-fold Carrier VFD Quick Reference Monitor Mode Carrier VFD Quick Reference For Carrier Drives Carrier VFD Quick Reference Record the following job information Record the following nameplate informationCarrier VFD Quick Reference Test Equipment Needed To Troubleshoot Verifying That DC Bus Capacitors Are DischargedPOS NEG TP1 TP2 Initial DC Bus Checking the Power Modules and Motor with Input Power Off Igbt Fault Codes Troubleshooting the Drive Using Error CodesAlarm Codes Error LogIdentifying Alarm Codes and Recovering Alarm Code Description Alarm Cause Corrective ActionIdentifying Fault Codes and Recovering Fault Code Description Fault Cause Corrective ActionIPL OPL Asymmetrical Bus When Input Ground Fault ExcessiveSlow Ramp Rate of DC Bus DC Carrier VFD Quick Reference Troubleshooting the Drive Identifying Fatal Fault Codes and Recovering Code Fault Description Fault Cause Corrective ActionResetting a Checksum CHS Fault Indentifying PMC Board Fault Codes and RecoveringStatus of LEDs Fault Description Corrective Action Model Amps Code Number DIF Technical Writing Internal UsePage Page Publication D2-3466-2 May 2005 -- Supercedes D2-3466-1 June