Alesis NANOVERB-2 quick start Troubleshooting Guide, Symptom Cause Solution

TROUBLESHOOTING GUIDE

SYMPTOM	CAUSE	SOLUTION
The Power LED does not	No power	Check that the power cable
light when the unit is		is plugged in properly
powered on
Sound is distorted, signal	Input level is too high	Turn down the Input Level
LED is lit red		control
Sound is excessively noisy	Input level is too low	Turn up the Input Level
		control
Green “Input” LED barely lit	Output level is too low	Turn Output up and reduce
	and Aux Return on mixer	Aux Return level on mixer
	is up full
No audio is heard	Bypass function is on	Turn the Mix control to the
	with Mix turned 100%	left or press the Bypass
	wet	footswitch
	Output level is too low	Turn the Output control to
		the right
Hum or noise from output	Ground loop, unshielded	Try plugging the unit into
	cables	another power outlet or use
		different audio cables

6