NETWORK SETUP 4
After entering the correct TCP/IP settings you will be ready for "Port Forwarding" (Case B).
wPlease record the TCP/IP settings of your 7700 for future reference. You may need this information to access your 7700 and to configure "Port Forwarding".
7700 TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
DDNS Server
Web Server Port
Video Server Port
wAfter clicking "Apply" the system will prompt for a reboot. Please allow the system 30 seconds to reboot and accept the changes. After 30 seconds, close the configuration screen. The view will display "Trying to Reconnect". If the ACTIVE light on the 7700 has gone off and is now back on again flashing, then the 7700 has rebooted. After the system reboots completely, remove the power supply from the unit and close Internet Explorer.
wReturn your PC/Laptop TCP/IP properties to their original settings.
wBefore installing the 7700, you must use "Port Forwarding" on your personal router if you used Case B (Static IP with Router).
You will need to forward 2 ports:
w Web Server Port you assigned to the 7700. w Video Server Port you assigned to the 7700.
Both of these ports will be forwarded to the IP address you assigned to the 7700.
In the example above, you would forward: 8888 - 192.168.0.200 7777 - 192.168.0.200
For further information on how to use "Port Forwarding" please read Appendix C.
NETWORK SETUP 4
Starting the 7700
After correctly forwarding the Web Server Port and the Video Server Port through your router (if applicable), you may then install the 7700 in a proper location.
1.Connect the 7700 to your router, switch, hub, or cable/DSL modem (per your network scenario) via a Cat5/5e UTP Ethernet network cable.
2.Supply power to the 7700.
3.After 30 seconds, verify the indicators:
∙ POWER | Solid |
∙ 10M | Flickering/Solid |
4.After configuring Port Forwarding on your router (if necessary), you may then access your 7700 on your local network by opening Internet Explorer and specifying the IP address and Web Server Port that you have assigned to the 7700.
A.Examples: http://192.168.0.200:8888 or http://24.106.88.123
B.If you left your Web Server Port set to 80, then you don't need to specify the port in the Address Bar when accessing the 7700.
5.Access your 7700 via the Internet or LAN:
A.Open Internet Explorer.
B.Type the IP of the 7700.
Network Video Flex® 7700 Manual | Network Video Flex® 7700 Manual |