Ken-A-Vision 7700 instruction manual Installation

Page 4

7700 INSTALLATION 2

Back Panel

Power Supply Connector

Use the power jack to connect your regulated 12V DC power adapter.

10M LED

This green indicator should be flashing or glowing during normal operation. During a reboot or power cycling, it may take up to 30 seconds to initialize, negotiate your network speed, and begin operation at 10Mbps. If this light is not lit after 30 seconds of operation, check the network cable to ensure a proper connection. When a proper connection is met, the green indicator should immediately glow.

Network RJ45 Jack

The server is designed to operate on a 10/100 Mbps Ethernet network. Currently the server operates at 10 Mbps until future upgrades become available. This accepts standard RJ45 plugs and works with Ethernet CAT5 cables.

Analog Video Jack

With this port you can connect the 7700 to an analog video device such as a TV monitor, a LCD projector, or any other device that can accept an analog video input. Use a standard video RCA cable.

FAQ 8

I can't connect!

In the case of a connection failure, follow this sequence, letting each device finish fully rebooting:

Modem Reboot

Router Reboot

7700 Reboot

How do I choose a unique IP address that matches my network?

For your home or small office, ensure that all devices on your network are running. PING an IP address that you plan to assign to the 7700. If you receive a "Request timed out", then you may use that IP address. To ensure the IP address that you will assign the 7700 matches your network, review your "Current TCP/IP Settings" that you had recorded earlier. See some examples below:

wIf your "IP Address" entry in "Current TCP/IP Settings" was 192.168.0.y, and your "Subnet Mask" was 255.255.255.0 then use 192.168.0.x for your 7700's IP Address ("x" meaning any number between 2-254 that you wish, as long as it passes the "PING" test).

wOther private IP ranges are 10.0.0.0 - 10.255.255.255 and 172.16.0.0 - 172.31.255.255.

How do I open an MS-DOS or Command Prompt?

wWindows 98 / ME Users:

Start ' Programs ' Accessories ' MS-DOS prompt

wWindows 2000 / XP Users:

Start ' (All) Programs ' Accessories ' Command Prompt

How do I "PING" an IP address?

wOpen an MS-DOS (or Command) prompt

wAt the prompt type - "ping xxx.xxx.xxx.xxx" (without the quotes and replace the "x"s with an IP address)

wPress Enter

How do I enable or check ActiveX on my browser

Open Internet Explorer ' Tools on the menu bar ' Internet Options ' Security Tab ' Custom Level ' Scroll down and verify that you are prompted or have enabled ActiveX controls and plug-ins to be downloaded and executed ' Click OK ' Restart browser.

Network Video Flex® 7700 Manual

www.ken-a-vision.com

Network Video Flex® 7700 Manual

www.ken-a-vision.com

Image 4
Contents Email Support support@ken-a-vision.com 7700Contents FAQMy power switch is not lit IntroductionHow do I choose a private IP address? My 10M light is not flashing or solidInstallation Power Indicator AppendixFor D-Link DI-604 broadband routers For Linksys BEFSR41 Cable/DSL routersFor Windows 98 / ME Users For Windows 98 / ME Users Admin Tool Admin Tool Network Setup Static Video Tool Must have at least 2 static IPs received from your ISPWEB Viewer Network Setup Case C Static Fixed IP Dedicated line directly toStarting