Jiaye General Merchandise Co BTP-M280 user manual Cutter specification, Paper Specification

BTP-M280 User’s Manual

2.2 Cutter specification

Item	Parameters	Remark
Cut method	Sliding blade
Cut time	600ms	Time for one cutter action
Cut interval	2s	30 cuts/minutes (Max.)
Adapt Paper	65～100μm	Normal paper with same thickness
Operation voltage	24VDC
Max. repose current	1.2A	24VDC
Cutter lifetime	1,000,000cuts	Under standard test conditions

2.3 Paper Specification

2.3.1Continuous paper 1）Normal paper

¾Paper width: 80±0.5mm/76±0.5mm/69.5±0.5mm/57.5±0.5mm

¾Max. paper roll O/D: Φ83mm

¾Paper roll core: ID Φ12.5mm; OD Φ16mm

¾Paper thickness: 0.06—0.085mm

2）Multi-layer paper (1 original +1 copies)

¾Paper width: 80±0.5mm/76±0.5mm/69.5±0.5mm/57.5±0.5mm

¾Paper thickness: 0.05—0.08mm, total thickness≤0.14 mm

Caution:

—Use only multi-layer paper (1 original + 1 copies) of which the original layer on contact the print head thicker than its under-layer.

2.3.2 Marked paper

Besides the requirements of the continuous paper, marked paper should follow the following requirements:

1)Mark place

yBTP-M280 printer reserves 8 positions for mark sensor, which can detect marks on either the front side or the reverse side of the paper. Position of the sensor is as shown in the figure.

yThe position of the mark sensor can be adjusted according to user’s need. The default position (Position 1) is on the right side of the paper on the front side (paper feed direction) as shown in the figure.

2)B/M size should meet the requirement as follow:

y	Mark width (L1)：	5mm≤L1≤10mm
y	Mark height (L2)：	12mm≤L2≤ paper width
y Distance between marks (L3)：		20mm≤L3≤500mm

3)The black mark’s reflectivity should be less than 15%, and the other part’s reflectivity should be more than 85%. There should be no image between the two marks, such as the advertisement etc.

- 5 -