Klark Teknik DN9652 Mains input, Clock section, AES50 section DN9650 only, Control connector

Page 30

Chapter 4: Rear Panel

Mains input

Always replace the mains fuse with one of the same type and rating, as printed underneath the fuse drawer.

The mains input section has a mains IEC socket, mains fuse compartment and on/off switch. Printed underneath is the mains supply voltage and fuse specifications.

The mains input is an auto-voltage sensing switch mode power supply that operates where normal mains voltage is in the range 100V AC to 240V AC.

Mains IEC socket

Mains fuse compartment Mains on/off switch

Supply voltage and fuse information

Clock section

This section provides 75 ohm connections for two types of external clock for synchronisation:

BLACK BURST 75R A single INPUT socket provides connection for a video signal generator.

WORD CLOCK 75R An OUTPUT socket and an INPUT socket provide connection for an external word clock source.

BNC chassis connectors

AES50 section (DN9650 only)

The AES50 section of the DN9650 has three EtherCon® XLR chassis connectors for audio connections to/from a Midas digital system or AES-equipped device.

Each connector supports 24 bi-directional channels operating at a fixed sampling frequency of 96kHz for compatibility with existing Midas and Klark Teknik AES50-equipped products.

EtherCon® XLR connectors

CONTROL connector

A single EtherCon® XLR chassis connector lets you connect to a computer to enable unit configuration and software upgrade.

 

DN9650/DN9652 Network Bridge

16

Operator Manual

Image 30
Contents DN9650/DN9652 Page Important Safety Instructions Instructions DE Sécurité Importantes Klark Teknik Hereby declares that the following productPage SVP, Midas Klark Teknik AVP, Product Development Page Licences Page GNU General Public License GPL Page Contents Contents Installation Getting StartedUnpacking Connecting up the DN965X Getting StartedPowering the unit Powering the unitTo switch the unit on/off Configuring the unit for the first time Connecting a DN965X to a computerConfiguring the unit for the first time Getting Started Overview About the DN965X unitsKey features OverviewHost software version and updates Host software version and updatesChanging the network module Service and support About this manualTrademarks Front Panel Front Panel Klark Teknik roundel Has a blue backlightDN9650 Asrc LED status DN9652 Asrc LED statusFront Panel Rear Panel Item DescriptionClock section Control connectorMains input AES50 section DN9650 onlyConfiguring the DN965X About DN965X configurationAbout the web browser interface Configuring the DN965X Item Screen elementChanging the displayed text Setting up a network moduleTo configure a network module card Changing the displayed textClocking options To change the clocking options of a network moduleClocking Options Ethernet IP Addressing Ethernet IP AddressingTo change the IP address of the DN965X Updating the unit’s host software TAR files and recommended file upload orderSoftware Updating the unit’s host software Default IP address Default display Using a Madi module as a Madi split To configure the Madi module as a Madi splitOperation Operation Appendix a Technical Specification Appendix a Technical Specification Appendix B Functional Block Diagrams Appendix B Functional Block Diagrams DN9650DN9652 DN9652Appendix B Functional Block Diagrams Routine maintenance Appendix C Service InformationRestoring the factory defaults CleaningOptional equipment Special accessoriesChecking/replacing the mains fuse Equipment disposal