Klark Teknik Your Essential Guide to Network Bridge Configuration
Page 18

Chapter 1: Getting Started

Configuring the unit for the first time

Important:

Before you use the unit for the first time, you must configure your computer with the IP address and netmask to suit the range used by the DN965X.

Before you can use the DN965X as a network bridge, you must first configure it by choosing the type of network module card(s) that are fitted in the unit and then setting them up. Configuration involves connecting the DN965X to a computer running an up-to-date web browser. To make sure your computer is compatible with the DN965X, you will need to change its IP address and netmask. For more information on configuration, see Chapter 5 "Configuring the DN965X" on page 17.

>>To connect the DN965X to a computer and then open its configuration menu in the web browser

1Connect an Ethernet cable to the CONTROL socket on the rear panel of the DN965X and then to the Ethernet port of your computer.

Ethernet cable

Laptop PC/Mac

CONTROL

connector

Connecting a DN965X to a computer

2Switch on the DN965X and your computer. (Note the default IP address of the DN965X, which is displayed on its LCD screen during power up.)

3To make sure your computer is compatible with the DN965X, we recommend that you change the IP address and netmask of your computer to 192.168.2.1 and 255.255.0.0, respectively; for instructions, refer to your computer’s help and support information.

4Open your computer’s web browser.

Note: Make sure your web browser is up-to-date.

5In the web browser’s address bar, type in the following default IP address (displayed on the unit’s LCD screen during power up) and then press

ENTER:

“http://192.168.10.10”

Typical browser address bar

 

DN9650/DN9652 Network Bridge

4

Operator Manual

Page 17 Page 19
Image 18
Page 17 Page 19
Contents DN9650/DN9652 Page Important Safety Instructions Instructions DE Sécurité Importantes Klark Teknik Hereby declares that the following productPage SVP, Midas Klark Teknik AVP, Product Development Page Licences Page GNU General Public License GPL Page Contents Contents Installation Getting StartedUnpacking Connecting up the DN965X Getting StartedPowering the unit Powering the unitTo switch the unit on/off Configuring the unit for the first time Connecting a DN965X to a computerConfiguring the unit for the first time Getting Started Overview About the DN965X unitsKey features OverviewHost software version and updates Host software version and updatesChanging the network module Service and support About this manualTrademarks Front Panel Front Panel Klark Teknik roundel Has a blue backlightDN9650 Asrc LED status DN9652 Asrc LED statusFront Panel Rear Panel Item DescriptionClock section Control connectorMains input AES50 section DN9650 onlyConfiguring the DN965X About DN965X configurationAbout the web browser interface Configuring the DN965X Item Screen elementChanging the displayed text Setting up a network moduleTo configure a network module card Changing the displayed textClocking options To change the clocking options of a network moduleClocking Options Ethernet IP Addressing Ethernet IP AddressingTo change the IP address of the DN965X Updating the unit’s host software TAR files and recommended file upload orderSoftware Updating the unit’s host software Default IP address Default display Using a Madi module as a Madi split To configure the Madi module as a Madi splitOperation Operation Appendix a Technical Specification Appendix a Technical Specification Appendix B Functional Block Diagrams Appendix B Functional Block Diagrams DN9650DN9652 DN9652Appendix B Functional Block Diagrams Routine maintenance Appendix C Service InformationRestoring the factory defaults CleaningOptional equipment Special accessoriesChecking/replacing the mains fuse Equipment disposal
Top Page Image Contents