Klark Teknik Complete Manual for Ethernet IP Addressing in DN9650 and DN9652 Models

Page 35

Ethernet IP Addressing

Ethernet IP Addressing

The IP address (default 192.168.10.10) can be changed via the configuration menu to allow operation as part of an Ethernet network. The default netmask value is 255.255.0.0, but you can also modify this if you want.

>>To change the IP address of the DN965X

1In the IP Address section of the configuration window, click Change IP

Address.

2In the New IP Address after reboot field of the Change IP Address window, type in the desired IP address. The range is 0.0.0.0 to 254.254.254.254.

3In the New Netmask after reboot field, type in the desired netmask. The range is 0.0.0.0 to 255.255.255.255.

Note: If you change the netmask, you will have to reconfigure your computer’s IP address/netmask.

4Click OK. The Change IP Address window will close. The IP Address section of the configuration window will now display a new field, which informs yo what the new IP address will be after reboot. (This field will disappear after a reboot.)

Temporary IP address field

5For the new IP address and netmask to come into effect, reboot the DN965X by switching it off and then on again. (The new IP address will be displayed during startup.)

6To reconnect to the configuration web page you will need to type in the new

IP address in the browser’s address (see “To connect the DN965X to a computer and then open its configuration menu in the web browser” on page 4).

If you have changed the subnet, you will also have to reconfigure your computer’s IP address/subnet mask.

DN9650/DN9652 Network Bridge
Operator Manual	21

Image 35

Contents DN9650/DN9652 Page Important Safety Instructions Instructions DE Sécurité Importantes Hereby declares that the following product Klark TeknikPage SVP, Midas Klark Teknik AVP, Product Development Page Licences Page GNU General Public License GPL Page Contents Contents Unpacking InstallationGetting Started Getting Started Connecting up the DN965XTo switch the unit on/off Powering the unitPowering the unit Connecting a DN965X to a computer Configuring the unit for the first timeConfiguring the unit for the first time Getting Started About the DN965X units OverviewOverview Key featuresChanging the network module Host software version and updatesHost software version and updates Trademarks Service and supportAbout this manual Front Panel Klark Teknik roundel Has a blue backlight Front PanelDN9652 Asrc LED status DN9650 Asrc LED statusFront Panel Item Description Rear PanelAES50 section DN9650 only Control connectorMains input Clock sectionAbout the web browser interface Configuring the DN965XAbout DN965X configuration Item Screen element Configuring the DN965XChanging the displayed text Setting up a network moduleTo configure a network module card Changing the displayed textClocking Options Clocking optionsTo change the clocking options of a network module To change the IP address of the DN965X Ethernet IP AddressingEthernet IP Addressing Software Updating the unit’s host softwareTAR files and recommended file upload order Updating the unit’s host software Default IP address Default display Operation Using a Madi module as a Madi splitTo configure the Madi module as a Madi split Operation Appendix a Technical Specification Appendix a Technical Specification Appendix B Functional Block Diagrams DN9650 Appendix B Functional Block DiagramsDN9652 DN9652Appendix B Functional Block Diagrams Cleaning Appendix C Service InformationRestoring the factory defaults Routine maintenanceEquipment disposal Special accessoriesChecking/replacing the mains fuse Optional equipment