Updating the unit’s host software
3With the desired file displayed in the Choose Update File field, click OK. The Updating window will open, showing that the update is in progress.
4When the file has been updated you should see an Upgrade successfully transferred message (typically as shown below). Click the Click here to return to the main page link to go back to the configuration page.
However, if you see the following No file was uploaded message, you have probably selected an invalid update file. Click the Click here to return to the main page link to go back to the configuration page and try again.
5Repeat steps 1 to 4 for the remaining files, except the ‘apps’ file (see Table 3 “TAR files and recommended file upload order” on page 22).
6You are now ready to update the ‘apps’ file. Repeat steps 1 to 4. You should see the Upgrade successfully transferred message. However, this does not mean that the upgrade is complete!
You must wait until the unit has fully rebooted before operating it.
DN9650/DN9652 Network Bridge |
|
Operator Manual | 23 |