ICEU070A

Maintenance And Cleaning Instructions

GENERAL

The periods and the procedures for maintenance and cleaning are given as guides and are not to be construed as absolute or invariable. Cleaning, especially, will vary depending upon local water and ambient conditions and the ice volume produced; and, each ice machine must be maintained individually, in accordance with its particular location requirements.

Ice Machine

The following maintenance should be scheduled at least two times per year on these ice machines.

1.Check and/or replace the water filter (if used).

2.Check that the ice machine is leveled in side to side and in front to rear directions.

3.Check for water leaks and tighten drain line connections. Pour water down bin drain line to be sure that drain line is open and clear.

4.Check size, condition and texture of ice cubes. Perform adjustment of cube size control as required.

5.Check the bin thermostat to test shut-off.

Put a scoop full of ice cubes in contact with the bin thermostat bulb for at least one minute.

This should cause the ice maker to shut off. Within few seconds after the removal of the ice from bin thermostat bulb, the ice machine restarts.

NOTE. Within minutes after the ice is removed from the bulb holder tube, the sensing bulb inside the tube will warm up and cause the ice machine to restart. This control is factory set and should not be reset until testing is performed.

6. Check for refrigerant leaks.

NOTE. Standard equipped with an air condenser filter as well as a Cleaning Reminder Board to remind to the end user the need for the cleaning of the air filter or of the water system (Red Alarm Light ON Steady or Blinking respectively with machine in operation).

Clean - Replace Of Air Condenser Filter

1.Withdraw the air filter from the front through the opening of the front panel.

2.Remove the front panel.

3.Blow pressurized air on the opposite direction of the condenser air flow so to remove the dust accumulated. If pressurized air is not available, use tap water always in the counter flow air direction. Once cleaned shake it so to remove most of the accumulated water, then dry it using an hair dryer.

NOTE. In case the air filter strainer is damaged replace it with a new one.

4.Return the front panel to its normal position.

5.Install filter by pushing it through the front panel opening.

Page 14

Page 15 Page 17
Page 16
Image 16
Ice-O-Matic ICEU070A Maintenance And Cleaning Instructions, General, Ice Machine, Clean Replace Of Air Condenser Filter
Page 15 Page 17

ICEU070A specifications

The Ice-O-Matic ICEU070A is a high-performance ice machine designed for businesses that require a reliable source of clear, hard ice. This model stands out in the commercial ice machine market due to its efficient production capabilities, compact size, and advanced technologies that enhance operational efficiency.

One of the primary features of the ICEU070A is its ability to produce up to 700 pounds of ice per day, making it ideal for restaurants, bars, and hotels that need large quantities of ice for beverages and food preservation. The machine’s cubers produce crystal-clear, half-inch thick ice cubes, known for their durability and slow melting properties, which help maintain the integrity of drinks without excessive dilution.

The ICEU070A employs a self-contained condenser unit, simplifying installation and maintenance. This feature is particularly beneficial for businesses with limited space, as the unit does not require extensive plumbing or electrical work. Additionally, the compact design allows it to fit conveniently under counters or in tight spaces while still providing ample ice production.

One of the machine’s standout technologies is its advanced Air Cooler System, which allows it to operate efficiently in a variety of ambient temperatures. The machine is built with a stainless-steel exterior, ensuring longevity and durability, while also being easy to clean and maintain. The food-grade materials used in the construction minimize contamination risks, thus ensuring the safety and quality of the ice produced.

Another notable characteristic of the ICEU070A is its user-friendly control panel equipped with an onboard diagnostics system, which makes it easier to monitor the machine’s operation and troubleshoot any issues. The unit features a built-in water filter, which can help improve the quality and taste of the ice while reducing the need for frequent cleaning.

In terms of energy efficiency, the ICEU070A is designed to minimize water and energy consumption, making it an environmentally friendly choice for businesses looking to reduce their operational costs. Its reliable performance and consistent ice production make it a trusted option for establishments seeking a durable and effective solution for their ice-making needs.

Overall, the Ice-O-Matic ICEU070A combines efficiency, durability, and advanced technology, making it a top choice for commercial users requiring a dependable ice machine. With its robust features and compact design, it provides a perfect balance of performance and practicality, ensuring ice is always available when needed.
Top Page Image Contents