ICEU070A
Operating Instructions
Start Up
After having correctly installed the ice maker and completed the plumbing and electrical connections, perform the following
A. Remove the condenser air filter then remove the front panel, Locate the cleaning switch on the control box.
B. Switch the cleaning switch to the cleaning position. This will close the electrical circuit to the water inlet valve and to the hot gas valve.
C. Switch the power ON and push the green button switch. Unit will start up in charging cycle mode. During this cycle the components energized are:
Water Inlet Solenoid Valve
Hot Gas Solenoid Valve
Water Pump
Fan Motor
D. Operate the unit in the water charging cycle for about three/four minutes till water flows out from the drain hose, then move the cleaning switch to the operation position.
NOTE. During the charging cycle, the water inlet solenoid valve is energized. The water flows through the valve to the back side of the evaporator platen and then down to fill up the ice machine sump for the next freezing cycle.
Air Filter Removal
Green Power
Switch
Cleaning
Switch
Front View With Front Panel Removed
Page 6