Ice-O-Matic ICEU070A installation manual Specifications

ICEU070A

Specifications

The ice machine must be installed indoors in a controlled environment.

	Minimum	Maximum
Air Temp	500F.	950F.
Water Temp	400F.	1000F.
Water Pressure	20 PSI	80 PSI
Voltage	103.5	126.5

Operating the ice machine outside of the above limitations, or outdoors, is potentially damaging to the machine, and it is misuse of the machine. This may void the warranty.

Ice-O-Matic ice machines are designed and manufactured with the highest regard for safety and performance. They meet or exceed the standards of agencies like NSF and UL.

Ice-O-Matic assumes no liability or responsibility of any kind for products manufactured by Ice-O-Matic that have been altered in any way, including the use of any part and/or other components not specifically approved by Ice-O-Matic.

Ice-O-Matic reserves the right to make design changes and/or improvements at any time. Specifications and design are subject to change without notice.

UNPACKING AND INSPECTION

1.Call your authorized Ice-O-Matic Distributor or Dealer for proper installation.

2.Remove the front panel of the unit and inspect for any concealed damage. Notify carrier of your claim for the concealed damage.

3.Check that refrigerant lines do not rub against or touch other lines or surfaces, and that the fan blade moves freely.

4.Check that the compressor fits snugly onto all its mounting pads.

5.Remove all internal support packing and masking tape.

Model	Electrical (volts/Hz/phase)	Fuse Size	Amps	Condenser Type	Refrigerant Charge
ICEU070A	115/60/1	15	6	Forced Air	9.5 oz R-134a

			6"	25 5/8"	Door Opening: 12 1/8" wide by 8 1/4" tall
	15 3/16"			20 15/16"
28 7/8"		34 3/16"	Min for utility connections		2 11/16"	3 3/4"
	4 11/16"

5/8"

				1 9/16" Cord Set
1 13/16"	11 5/8"	Legs adjust to	16 1/8"	3 1/16"
		6" from base.
				3 7/16" Drain

8 1/8" 3/4" GAS / BSPP

Page 2