Multiquip b46s90 manual Inspection, Before Starting, Engine Oil Check

inspection

BLADE

PITCH

CABLE

YOKE

YOKE

EYELET

BRASS SET	BRASS SET
NUT #1
	NUT #2

4.Align the groove on the slider with the text "B" FINISH or "B" COMBO on the decal. The letter "B" stands for B-46 Walk-Behind Trowel

CAUTION

ALWAYS wear approved eye and hearing protection before operating the trowel.

NEVER place hands or feet inside the guard rings while the engine is running. ALWAYS shut the engine down before performing any kind of maintenance service on the trowel.

Figure 12. Pitch Cable Yoke Attachment

6.Using a wrench, tighten the brass set #2 nut up against the yoke boss. This will lock the cable in place.

7.Use a wrench and finish tightening the brass set #1 nut up against the yoke boss.

Pre-Load Adjustment (Quick Pitch™ Handle Only)

WARNING

The Quick Pitch™ handle is spring loaded, personal injury or damage could result from improper handling, installation or adjustment. Use extreme caution when installing this component.

1.After the Quick-Pitch™ handle has been installed on the trowel, spring pre-load adjustment will be required.

2.Locate the spring pre-load adjustment screw (Figure 13) on the underside of the handle tube.

ALIGNMENT

DECAL

PRELOAD TRIM INDICATOR

FINISH J COMBO FINISH B COMBO

		ADJUSTMENT
	R	SCREW
	TO
	INDICA
	B
D TRIM
PRELOAJ		SLIDER
		GROOVE

Before Starting

1.Read all safety instructions at the beginning of manual.

2.Clean the trowel, removing dirt and dust, particularly the engine cooling air inlet, carburetor and air cleaner.

3.Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required.

4.Check carburetor for external dirt and dust. Clean with dry compressed air.

5.Check fastening nuts and bolts for tightness.

Engine Oil Check

1.To check the engine oil level, place the trowel on secure level ground with the engine stopped.

2.Remove the dipstick from the engine oil filler hole (Figure 14) and wipe clean.

Figure 14. Engine Oil Dipstick Removal Figure 13. Spring Pre-Load Adjustment

3.A decal has been placed on the side of the handle tube to assist the user in the adjustment of the spring.

b46s90 WALK-BEHIND TROWEL • operatION And parts manual — rev. #0 (06/13/13) — page 19