MSC CX-MB-EVA2 IDE Interface, HDA codec, Primary IDE Channel, 10.1.1.1 40-pin IDE interface

Page 31

CX-MB-EVA2 User's Manual

Hardware

 

 

4.9.2HDA codec

Specification:

￿ References: X39

￿ Connector: Foxconn JAS331-H1G2-4F

￿Pinout: Refer to Table 12

Con

 

colour

Function

1

 

light blue

Line In

2

 

lime

Line Out

3

 

pink

Mikrofon

4

 

orange

Center / LFE

5

 

black

Surround

6

 

grey

Side

Table 17

Pinout LineOut

 

4.10IDE Interface

A standard IDE interface is provided according to ATA/ATAPI, with the controller supporting at least Ultra-ATA100 with 100 MB/sec data rate. The transfer mode that can be selected depends on the cable used and which modes are supported by the drives.

Using a ATA100 cable on X22, avoid a master slave combination with X23 or X24.

4.10.1Primary IDE Channel

4.10.1.1.140-pin IDE interface

A 40-pin IDC connector is provided at the primary IDE channel for standard IDE drives.

Specification:

￿ References: X22

￿ Connector: FCI 75869-118

￿Pinout: Refer to Specification ATA/ATAPI-6 [6, page 400, Table A3]

4.10.1.1.244-pin IDE Interface

For connection of 2.5” hard disks, a 44-pin IDC connector is provided at the primary IDE channel.

Specification:

￿ References: X23

￿ Connector:

Yamaichi ZP7-44-S-G

￿Pinout: Refer to Specification ATA/ATAPI-6 [6, page 412, Table A16]

31

Image 31
Contents User’s Manual EMC Rules Trademarks Copyright NoticeImportant Information DisclaimerHardware Preface General InformationIntroduction MechanicsLCD Eeprom SW0611 Illustrations Tables Reference Documents Revisions and ModificationsRevision Date Comment January 14 First release Definitions and Abbreviations Product Description FeaturesIntroduction Illustration 1 Block Diagram Base Board Block DiagramIllustration 2 Positioning of the Connectors Positioning of the ConnectorsAssembly notes DimensionsPlug-in Position of the COM Express module SpecificationACRST# COMExpress Connector Rows a and B PCIRESET# IDECBLID# PCI Slots Assignment PCI slot to connector reference SpecificationFRAME# PCI Express x1 Slots Assignment PCIe Lane to connector reference SpecificationPCI Express x16 Graphics Slot A36 PERn4 B36 VGA Interface Lvds Eeprom LVDS-InterfaceBacklight Inverter Interface JILI40 Connector Standard Jili ConnectorJili Interface TV Out 1 AC97 codec AudioMono-Microphone Pinout LineIn Stereo LineOut Specification Stereo LineIn SpecificationPinout LineOut Stereo Headphone Specification 10.1.1.1 40-pin IDE interface IDE InterfaceHDA codec Primary IDE ChannelSATA-Interface Specification Power SupplyCompact Flash Interface USB Topology USB Power SupplyLPC Slot Ethernet15 I/O Connector Gpio ATX ConnectorSpecification ATX connector Specification ATX12V connectorInterfaces used by the SuperIO Characteristics of the COM portsSuperIO COM Ports18.3 PS/2 IrDAMonitored voltages Fan interfaceIntel Fan interface SuperIO Hardware MonitorSerial Eeprom on SMBus SMB Hardware MonitorSerial Eeprom on I2C-Bus POST-Code Display OnBoard BIOS-FlashLattice Programming Interface Beeper BatteryPower Button Reset ButtonSleep State LED Display Ground PinsMiscellaneous Resistors for current measuringJumper settings ATX Funktion Jumper J1301 Battery Jumper J1101Super I/O disable Jumper J6 SMBus Hardware monitor address Jumper J1303DIP-switch settings