Hardware | |
|
|
4.13Ethernet
The base board can be connected to a local area network with an Ethernet interface. The COM Express module already provides MDI signals, so that only the transformer on the base board required.
The transformer PULSE H 5004 not only supports 10BaseT and 100BaseTX but also 1Gbit.
Specification:
References: X33
Connector: AMP
Pinout: Refer to IEEE Std. 802.3 [9, section three, page 225]
4.14LPC Slot
An LPC slot is available for insertion of LPC expansion boards.
Specification:
References: X34
Connector: |
Pinout: Refer to Table 15
Pin | Signal | Pin | Signal |
1 | VCC5V | 2 | VCC5V |
3 | NC | 4 | VCC3V3 |
5 | VCC3V3 | 6 | NC |
7 | VCC3V3_SBY | 8 | GND |
9 | GND | 10 | LPC_RST# |
11 | GND | 12 | LPC_LAD0 |
13 | LPC_LAD1 | 14 | LPC_LAD2 |
15 | LPC_LAD3 | 16 | LPC_FRAME# |
17 | GND | 18 | LPC_DRQ0 |
19 | GND | 20 | LPC_CLK |
21 | GND | 22 | LPC_PWRDWN |
23 | GND | 24 | PME# |
25 | GND | 26 | LPC_SMI# |
27 | GND | 28 | SERIRQ |
29 | GND | 30 | PCI_CLKRUN# |
31 | GND | 32 | LPC_DRQ1# |
33 | GND | 34 | CPU_RST# |
35 | GND | 36 | GND |
Table 20 Pinout
34