Monster Cable HTUPS500 owner manual

Page 16

3.Aim the attached device’s original remote control to the HTUPS’s front panel IR sensor. Now press and release the POWER/STANDBY (or it’s equivalent) button on the remote control. Approximately ten seconds after receiving the IR command sequence from the remote control, the LEARN LED will turn off, indicating that the unit has learned

the IR command sequence transmitted by the device’s remote control.

To test the automatic power-down of the attached device using the HTUPS’s

TEST button (after performing the above described programming steps):

1.Turn on the attached device.

2.Press and release the TEST button of the HTUPS. The attached device should start its power-down sequence and will go into stand-by mode.

3.Press and release the TEST button of the unit again. The attached device should remain in standby mode. This is to verify that the HTUPS will not unnecessarily turn on the device when it changes mode of operation.

To test the automatic power-down of the attached device

(after performing the above described programming steps in actual situations):

1.Power on the attached device, allowing it to completely power on.

2.Switch off the AC mains power to the HTUPS to let it run on battery mode. The HTUPS will transmit the IR ON/OFF code for the attached device. Consequently, the attached device should start its power-down sequence

and will go into standby mode.

3.Restore the AC mains power to the HTUPS to let it go back to ‘Normal’ mode. The unit will detect that the load is in standby/OFF mode and inhibits transmission of IR code. Consequently, the attached device should remain in standby mode.

11

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Htups Table of Contents Important Safety Instructions Page Iii Dear Enthusiast Noel LeeHead Monster Page Minds Behind the Monster Powercenter Design Monster Htups 500 Features Htups 500 Front ViewHtups 500 Features Page Powering Your Htups 500 and Connected Equipment HOOK-UP and Operation InstructionsTV/Monitor, Video Accessory Connections as follows HOOK-UP GuideMonster Htups IR Controller Before programming the unitPage Service Technician Battery Service Guide Service Technician Battery Service Guide Slide front panel in this direction to detach Troubleshooting Please see warranty informationFor three seconds to turn on the unit Is defectiveHtups 500 is defective Please see warranty information Power cord is loose250V AC fuse Alarm beeps continuously For at least 16 hours120VAC/6.0A/60Hz Line-Neutral L-N Line-Ground L-G Neutral-Ground N-GJoules Less than 1 Nanosecond 1NsHtups Table DES Matières Consignes DE Sécurité Importantes Conserver CES Instructions Mise EN Garde Sources d’alimentation Ignorez le type d’alimentation électrique de votre domicileMise EN Garde Mise hors tension du Htups Message DE Head Monster Cher passionnéLe Head Monster Page LES Cerveaux À L’ORIGINE DU Concept DU Powercenter Monster Caractéristiques DU Htups 500 Monster Htups VUE FrontaleCaractéristiques DU Htups Page Instructions DE Branchement ET D’UTILISATION RemarquePage Guide DE Branchement Commande À Infrarouge DU Htups Monster Avant de programmer l’unitéPage Page Mettez l’appareil sous tension Remplacement de la batterie Dépannage Mode batterie Le Htups Le cordon d’alimentation est mal connectéEst toujours en Un fusible c.a. a sauté’autonomie de la batterie La batterie n’est pas Spécifications Techniques Htups 500 Powercenter Page RM INTHTUPS500MAN
Top Page Image Contents