Monster Cable HTUPS500 owner manual Monster Htups IR Controller, Before programming the unit

MONSTER® HTUPS IR CONTROLLER

Before programming the unit:

1.Plug the line cord into a convenient AC outlet.

2.After powering on the HTUPS, its on-board controller will start a POST (Power On Self Test), indicated by both

the LEARN and TEST lights being illuminated. Upon successful completion of the POST, the unit’s on-board infrared controller will disable both the LEARN and TEST lights.

3.Plug the line cord of the device to be protected into the appropriate HTUPS power outlet.

4.Power on the device attached to the unit.

To program, or ‘TEACH,’ the unit the AC current draw of the attached device:

1.Turn on the device plugged to the HTUPS outlets, allowing the attached device to completely power on.

2.Simultaneously press and hold both the LEARN and TEST buttons on the HTUPS’s rear panel for five seconds. Both the LEARN and TEST LEDs will blink on and off three times, indicating that the HTUPS has completed its learning operation. The HTUPS has learned the AC power draw of the attached device and will use it as a reference for future operations.

To program, or ‘TEACH,’ the unit the remote control sequence for powering down the attached device:

1.Power on the device attached to the HTUPS, allowing the attached device to completely power on.

2.Simultaneously press and hold the LEARN button of the unit for three seconds. The LEARN light will turn on and stay illuminated.

10