Monster Cable HTUPS500 owner manual Service Technician Battery Service Guide

Page 18

SERVICE TECHNICIAN

BATTERY SERVICE GUIDE

WARNING – Battery replacement to be performed by qualified service technician only.

13.Replace the front panel and tighten its screws.

14.Reconnect the load.

15.Reconnect the input AC cable.

16.Turn on the HTUPS.

17.Press and hold the power switch for 4 seconds. The HTUPS will initiate a self-test and will automatically revert to normal operation.

18.Switch on the load.

Please recycle the spent battery. Do not dispose it in household waste.

Please check for recycling programs in your area.

13

Image 18

Contents Htups Table of Contents Important Safety Instructions Page Iii Dear Enthusiast Noel LeeHead Monster Page Minds Behind the Monster Powercenter Design Monster Htups 500 Features Htups 500 Front ViewHtups 500 Features Page Powering Your Htups 500 and Connected Equipment HOOK-UP and Operation InstructionsTV/Monitor, Video Accessory Connections as follows HOOK-UP GuideMonster Htups IR Controller Before programming the unitPage Service Technician Battery Service Guide Service Technician Battery Service Guide Slide front panel in this direction to detach For three seconds to turn on the unit TroubleshootingPlease see warranty information Is defectivePower cord is loose Htups 500 is defective Please see warranty information250V AC fuse Alarm beeps continuously For at least 16 hoursJoules 120VAC/6.0A/60Hz Line-Neutral L-NLine-Ground L-G Neutral-Ground N-G Less than 1 Nanosecond 1NsHtups Table DES Matières Consignes DE Sécurité Importantes Conserver CES Instructions Mise EN Garde Sources d’alimentation Ignorez le type d’alimentation électrique de votre domicileMise EN Garde Mise hors tension du Htups Message DE Head Monster Cher passionnéLe Head Monster Page LES Cerveaux À L’ORIGINE DU Concept DU Powercenter Monster Caractéristiques DU Htups 500 Monster Htups VUE FrontaleCaractéristiques DU Htups Page Instructions DE Branchement ET D’UTILISATION RemarquePage Guide DE Branchement Commande À Infrarouge DU Htups Monster Avant de programmer l’unitéPage Page Mettez l’appareil sous tension Remplacement de la batterie Dépannage Est toujours en Mode batterieLe Htups Le cordon d’alimentation est mal connecté Un fusible c.a. a sauté’autonomie de la batterie La batterie n’est pas Spécifications Techniques Htups 500 Powercenter Page RM INTHTUPS500MAN