Mobility Electronics PS6U1UHE manual Configuring eConnect

InVision USB-Host to Ethernet Adapter User Guide

‰After the CAB file installation completes, you will need to warm boot the MC1000 by pressing and holding the red ON/OFF button until the device resets. This process will add eConnect to your Applications Folder. Consult your MC1000 documentation if you need help with performing a warm boot.

Be careful when performing a “warm boot” on the MC1000. The same activity that initiates a “warm boot” will also initiate a “cold boot.” They are only a matter of seconds apart between a “warm” or “cold” boot. The results, however, can be significant. A “cold boot” will remove all data and applications and return the MC1000 to a default factory status. You can relax a little, however, because eConnect will automatically reinstall itself for you.

Step 5 – Configuring eConnect™

‰Open the Applications folder, and highlight the eConnect icon. Press the ENTER button to display the eConnect Properties dialog.

‰When eConnect Propertied dialog opens, you can configure eConnect as follows:

ƒUse eConnect for Docking Events When checked, eConnect will automatically sense when the terminal is inserted into a cradle and will carry out the options you have selected in the When Docked area.

ƒWhen Docked

oLaunch ActiveSync – If checked, the terminal will attempt synchronization when a connection is detected. This can

happen only if the terminal and a PC have a previously established partnership. ActiveSync is launched with the system settings established by the user.

Checking this option automatically un-checks the next two options, if either of them was checked.

oEstablish TCP/IP Connection – Establishes a TCP/IP connection with the cradle, allowing applications to bypass ActiveSync and communicate directly with nodes on a network via TCP/IP.

Checking this option automatically un-checks the “Launch ActiveSync” option, if it was checked.

oLaunch Application – Specifies that eConnect should automatically launch an application when you cradle the terminal. Any file that has an association with a registered program will run. You may also elect to launch a shortcut if the session needs special settings or command line parameters.

Mobility Electronics, Inc 4